Can't get the 2007 Charger out of park! ME TOO!!! i just wanted to go to blockbuster and buy a lotto ticket and it wouldnt shift !!!! everything else is fine and i checked the whole car and i didnt see any leaks or anything the car was fine never had no problems!!! the shift was always smooth but what the F@#****!!!! the car only has 25,000 miles !!!! and now im stuck in park!!!! well at least this happened infront of my house somebody please help!!!
Go to automotix.net There is a recall on your make and model because of that same problem.
Posted on Jun 09, 2009
2006 charger won't shift out of park ...park lock solenoid ?
http://www.custombilletstore.com/product_p/1028.htm I know this is late but I had the same problem. The release wouldn't work either. I had to remove the shifter and take the cover off. A spring broke off the pink lever in the front of the shifter. The shifter would move side to side but couldn't be pulled back. The above link sells a replacement part that might work. Thanks to petevpi.
Posted on Jul 23, 2009
fuse box diagram for 2006 dodge charger sxt - front and back box's-
Find your solution from bellow
» Mazda ( 3781 Solution )
» Mercury ( 8762 Solution )
» Mitsubishi ( 4765 Solution )
» Nissan ( 7654 Solution )
» Oldsmobile ( 2467 Solution )
» Pontiac (1986 Solution )
» Saturn ( 3997 Solution )
» Subaru ( 4225 Solution )
» Suzuki ( 4832 Solution )
» BMW ( 3876 Solution )
» Buick ( 2987 Solution )
» Chevrolet (12345 Solution )
» Chrysler ( 3456 Solution )
» Dodge ( 4765 Solution )
» Ford ( 11345 Solution )
» GMC ( 6754 Solution )
» Honda ( 8943 Solution )
» Hyundai ( 4187 Solution )
» Jaguar ( 2876 Solution )
» Lincoln ( 3346 Solution )
» Toyota ( 9761 Solution )
» Volkswagen ( 4681 Solution )
» Volvo ( 2875 Solution )
110.21
Posted on Sep 12, 2009
where is EGR Valve located on a 2006 dodge charger 3.5L pic would be helpful
to find the egr valve you will have to remove the purge soleniod from the bracket.
1. EGR tube
2. EGR Valve
Posted on Oct 04, 2009
my radiator fan is not working on my 2006 Dodge Charger
Hi, If you have truble code check/service engine soon light on,then go to your local Autozone part store for a free scan. If not,i'm going to start with haveing you check the cooling fan relay,this can be found in the power distribution box,this can be found in the engine compartment.I would change places with another relay with the same number on it. If this takes care of it,buy a new relay and it was an easy fix. If not here's tests you will have to do as long as you have a digital volt meter.
Operation
The Engine Coolant Temperature (ECT) sensor is used to sense engine coolant temperature. The sensor protrudes into an engine water jacket.
The ECT sensor is a two-wire Negative Thermal Coefficient (NTC) sensor. Meaning, as engine coolant temperature increases, resistance (voltage) in the sensor decreases. As temperature decreases, resistance (voltage) in the sensor increases.
The PCM compares the ECT, Intake Air Temperature (IAT), and Ambient Air Temperature (AAT) under cold start conditions. Following a start to run delay time, the sensor values are compared. If the one sensor value is not within a specified range of the other two sensors, the value is determined to be irrational
2.7L, 3.5L & 5.7L Engines
I hope this helps,Thank You for using fixya, iluv2fish..... Ray.......
Posted on Jun 30, 2010
what do the code u0100 mean on dodge charger 2006
Hi,
The U0100 code means there is Loss in communication with the ECM/PCM,which might be as a result of one of the following reasons listed below.
1. You had flash downloads applied to your vehicle. Many erroneous DTC codes are generated during flashing and should be cleared after flashing
2. You disconnected/reconnected computers in the car with the power still applied
3. An interruption (break or short) in the CAN network caused communication errors.
a simple software update will help you resolve the issue.
Good luck,
Posted on Aug 28, 2010
how do i clear code b223D on dodge charger
This is not an error code. It pinpoints that other error codes might require your attention as it is an OCM (Occupant Classification-ECU) DTC present. The chances that the error is due to an uncalibrated seat. Get it read by a scanner, or take it to a dealer or car mechanic to reset.
Posted on Apr 28, 2020
2006' Dodge Charger will not turn on. New Battery, starter tested and passed. Key tested and passed. It has the factory keyless entry. It worked fine prior.
check ignition switch (eletronic)
Posted on Mar 07, 2012
Reprogram 2009 Dodge Charger Key Fob
George....
What year/make/model does your programing solution apply to? It certainly does NOT apply to the 2009 Charger in this post. There is no circuit on pin 1 of the DLC, pin 1 is empty, therefore jumping it to pin 4 (chassis ground) will do nothing.
as for the original question it would be nice to know if the charger is having problems with the key fob unlocking the doors or starting the car.
A dealer can program keys, so can a lot of independents, there are also Lock Smiths and Mobile Mechanics who can do the job.
Most programing on late model vehicles require specialized equipment and it is ALWAYS a good idea to scan for codes in all models to identify problems before attempting any programming.
Chrysler is particularly susceptible to failures in the SKIM and WIN models.
My advice is to seek out a qualified professional with the proper equipment and experience. This is not a DIY project
Robert Grove, www.wego2umobilemechanic.com
Orange County Mobile Mechanics 714 709 4594
Posted on Feb 28, 2014
need diagram for cooling system, hose flow and locations 2006 charger 5.7 hemi
Here is a diagram. The system is reverse flow like all modern engines to control detonation.
Posted on Sep 21, 2016
1,219 questions posted
Usually answered in minutes!
164 Questions
66 Questions
66 Questions
43 Questions
53 Questions