20 Most Recent 2006 Dodge Stratus - Page 9 Questions & Answers

Hello there , try your battery terminals. The smaller wires that go to your terminals can be electronic ignition , if there connection is dirty or the in line fuse is corrosive your motor will turn over and not start. .. Regards Graham ....

bad horn switch in steering wheel, fun job good luck

need more info, my first thought is check all the filters air and fuel, do you have a check engine light on, if not its probably a filter problem

is it unde rthe tire ? front my my serbing or can u get to it under hood ? if its tire one u hav eto remove fornt left tire take out platsi stuff then thers batter behind wall k thx nick

Code 340 is for a problem with the cam sensor or circuit.

sounds like the fan resistor is bad you can get them at any parts shop and are held in with 2 screws and one electrical connector

Hi!!
Take off the cover of the fuse box and look on the inside, there is a diagram of the fuses locations and names.
Don't forget to rate this post!!

how does one remove the back 3 spark plug on the 06 V6 stratus

There is no relay for the windows, if all windows aren't working, check the fuse (#2). It could also be a faulty windows on/off switch on the drivers side.

Some basics could be the ignition switch (key) itself. Dirt, grime, etc. could interfere with the connection. Fusible linkages and fuses, on board computer, antitheft device (kill switch), etc. to name a few more.You likely require a copy of the vehicle\'s wiring diagram to figure this one out - or bring it to your dealer / trusted mechanic. Auto electrics can be a real pain in the backsideGood luck!

This car has coils if has look #2 coil and follow wire.

For best results use champion oe plugs.copper core plugs run hotter have an 06 myself i put platinum plugs in and the car run like S@#t.Spark plug gap should be .44-.48

open the trunk and either left or right you will see big black wing nuts loosen there is 3 of them push out tail light housing turn plug 1/4 Turn Then Pull out Bulb Reverse process To Reinstall

Check For Runout (Wrapped Rotors) Measure to confrim there is enough to machine and still stay within o.e. specs