When I am driving my 2005 Nissan Maxima when I start to slow down and start to release the brake around 40 miles per hour I hear a very loud tapping noise in the front end. The roaters have been replaced on both sides, and also the brake shoes have been replaced and it still continues to tap. Can somebody help me?
it would not hurt to check rear tire wear due to misalignment
cupped tires will cause a faulty bearing type noise or humming.
Posted on Aug 27, 2008
SES light on. U1000 code appears on diagnostic test @ Jiffy Lube. What does it mean? They have not seen that code before. I tightened gas cap, it was lose. Waiting on dealer to give me an ear-full of problems. help!
u 1000 is a communication fault code
Posted on May 21, 2009
U1000 Diagnostics check pop-up
U1000 is a CAN Communication fault code. it is a code that most nissans have that cannot be cleared. does not indicate a fault with any system. if that is the only code in the system then ignore it, does not affect the car
Posted on Jul 04, 2009
checked the brakes new tires had front end checked and aligned.
Wheel bearing !!
Posted on Aug 16, 2009
how many labor hours to remove and replace a transmission in 2005 nissan maxi
ABOUT 4-6 HOURS OF LABOR, DEPENDS ON WERE U HAVE IT DONE..
Posted on Nov 10, 2009
replacing headlight bulb on a 2005 nissan maxima
Hi,
You can purchase a Haynes Manual or go on-line to nissantechinfo.com and purchase the factory service manual in .pdf format and download it for around $20 bucks for an hour of access. If yours is an HID bulb the cost is mostly the bulb. And, if you are not familiar with HID then I would let them do it. But, if you feel comfortable just jack up the car on the driver's/passanger side and remove the tire to get access to the inner fender well. Remove the clips and screws and you now have access to the back of the headlight assembly. Remove the access cover on the assembly and you will find the back of the bulb. If it just a turn and the access cover comes off and then the same for the bulb.
Posted on Jan 22, 2010
knock sensor location 2004 maxima
under the intake manifold in the valley between the cylinder heads
Posted on Jan 07, 2017
code p0340 wicht sensor is it
I am not sure what "slip n tcs" means but on the 2005 nissan maxima the code P0340 is for the camshaft position sensor circit on bank 1, which is in the rear of the engine compartment. Code P0345 is for camshaft position on bank 2, which is in the front of the engine compartment. The images show the Cyl banks and a cam sensor.
Posted on Jun 29, 2012
Do I have to take it to the dealership. Can a local mechanic do the job.
The shop cost here is 1274.00,which it says they use a timing chain kit.Takes 9.1 hours to do job and 86.00 per hour,Dealer is about 100.00 per hour.It says 509.00 for parts,the do it yourselfer is 426.00 for parts and 11.6 hours to do job.
Posted on Jan 07, 2013
I just put new headlight hid and it still does not work . Is there a fuse or relay. If so where is it located
yes there are 2 fuses under hood inside fuse box. fuses are for l/h head light and r/h head light. check those.
Posted on Apr 04, 2014
659 questions posted
Usually answered in minutes!
1,309 Questions
1,122 Questions
1,007 Questions
857 Questions
783 Questions