20 Most Recent
2003 Mitsubishi Lancer - Page 9 Questions & Answers
Sanden compressor oil leak
If you have an oil leak in a a/c compressor you have no gas as the oil travels with the gas around the system. If the leak is behind the pulley clutch it is p[ossible to have it replaced and if it is at a fitting have the line replaced You will have to regas the system when done and fit a new receiver dryier as well.A quantity of oil will also have to be added.
Check engine soon light is on, in my 2002 Lancher. What does it mean?
The yellow "Check Engine" or "Service Engine Soon" light is an informational indication to you to let you know that the computer has detected a problem with the engine that needs to be checked.If a RED indication - this means that the there is a problem the requires immediate attention. This usually means shutting off the engine and stopping for the case of a RED oil, temperature, brake, etc message.The yellow indication means that the engine has a problem that is not noticeable to you - at least at first - but left unchecked could result in costly repairs. Many of the problems associated with this YELLOW indicator are related to fuel & emmissions systems, such as faulty oxygen sensor, fuel sensor, mis-firing, low engine temperature, and much, much more. These can cause fuel economy to suffer and very hot exhaust components or even failure of the catalytic converter. Drive the car to wherever you're going - but make appointment to have it checked out. Many Auto parts stores such as Auto Zone will be happy to use their tool to "scan" the fault code stored in the computer. This code will help you narrow down the problem and potentially save you from having your mechanic simply tighten your gas cap (and yes - a loose gas cap can trigger this light!).I hope this helps and good luck!
Gauges all Dead
i think that u have a problem with RPM cause this problem is not always being with ur car.
My 2003 lancer over heated and won't start now.
too late, but the answer is: when the water system loses enough water, there is a sensor in the water inlet that tells the computer that there is no water, then the computer will not allow the engine to start, I check it on a radiator change I had to make a lancer 2006, we wanted to move the car a few meters but did not start because the hoses were not installed and the block had no water, so we had to start pouring water with a garden hose to the water inlet of the block and in that way started the engine.
Not finding what you are looking for?