20 Most Recent 2006 Mazda 3 - Page 2 Questions & Answers

possible that the harnesss and connections to the TCM are damaged ,full of snow or water it indicates that the torque converter clutch servo/solenoid is not getting a message about the selector position or is damaged

certamente il codice indica che non c'? comunicazione tra il cambio automatico e il traction control module o centrallina controllare il cablaggio e connettori

Check to make sure the transmission is not on drive. If so put it back on park then try to start it.

Throttle body sensor if changeable or complete t-body I’m happy to assist further over the phone at https://www.6ya.com/expert/howard_977676954994c5b2

P1277 - Cylinder #7 High To Low Side Open https://www.autocodes.com/p1277.html

It has a chain as far as I can tell.

whist driving or when you start

could be number of things need to be pluged in to diagnostic to see the fault code then will be directed

thromstat connector need changing. as the setting is not working

Yes. However unless you are very familiar with remote start installation have a qualified authorized dealer install it. It is very easy to cause permanent damage to the car.

Is there any grinding? You may need new front brake pads. I might also have the brakes bleed for there may be air in brake line. Thank you and Please leave feedback

You will need to replace the ignition lock cylinder.

The transmission touble light is on? This means it is holding a trouble code to tell you what is the problem. First thing is to get that code read out to see what to do next. Any mechanic can do this, or in the USA, Autozone. One possibility is that the transmission 1/2 shift solenoid has failed, making it unable to find low gears.That will be a code like P1752. .

there may be a mechanical problem in the trans mission with that mileage it may be that it needs overhauled try a transmission specialist not the dealer