20 Most Recent
2005 Buick LaCrosse - Page 10 Questions & Answers
WE HAVE REPLACED THE BRAKE PADS, AND CALIPER AND
Can you post some pics? The screws on the rotor are there to hold things together while the vehicle is assembled. If there are bolts/screws holding the rotor to the hub they do not need to be reinstalled. However I think you may have other issues. Can you turn the rotor without the wheel on by hand with the crew tight? A you sure you have the right parts? I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
My back up sensor wont work
Try checking fuse box to see if it has a blown fuse, you probably got 2 fuse boxes, 1 under dash and 1 under hood compartment, check both boxes for blown fuse, k hope it works, Billy Wyatt
Keys won,t lock or unlock doors
Use this Procedure for Buick Vehicles "With" Driver Information Center Buttons.
This information is in your "Owners Manual" in the "Drivers Information Center Section."
1. Insert Key and turn to ON position so you can access Driver Information Center.
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays.
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays.
4. Press and hold the lock and unlock buttons on the key-less remote at the same
time for approximately 15 seconds. A chime will sound indicating that the remote is
programmed.
5. To program additional remotes at this time repeat step 4. This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove key. Test remote(s).
Use this Procedure for Buick Vehicles "Without" Drivers Information Center Buttons.
To access this display, the vehicle must be in Park (P) with key in the
on position (as far as you can go without cranking engine).
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the first key-less remote at the same
time for approximately 15 seconds. A chime will sound indicating that the remote is
programmed.
4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key. Test remote(s).
Good Luck !
Not finding what you are looking for?