Top 20
2008 Mitsubishi Endeavor Questions & Answers
Pulley Noise
Remove belt and spin each pulley to check for smoothness or noise.
Where is the code reader port on the 2008 Mitsubishi Endeavor?
It is under the driver's kick panel. Occasionally, they are under the passenger's kick panel. (Remember, the Japanese drive from the right-hand side and some car designs are not switched over completely for our LHD in NAFTA countries and Continental Europe.) The socket has 21 pins on it as I remember.
Starter?
Sounds like you have a weak battery..try giving it a good charge and try again many times engines will not start with a battery that turns the engine over but not fast enough to start.. Good luck.
Mitsubishi codepo 551s
2008?
does car run? and move?
is the Check engine lamp glowing , moving?
yes, and you scanned it and got just ONE DTC?
P0551, (which engine option do you have?)
that code is power steering fail.
check fuses first
use a scan tool to reset the errors
test drive car see if it returns.
same answer any car.
if comes back ,
the sensor is bad,
or its wires fell off.
or you are turning the steering real hard in to a curb and overloaded it.
in the later case, stop that, or we tell you mum.
Why won't rear window let up?
is it electric ? if so check the fuse , the switch if both ok then i suspect it is the window actuator /motor assembly
Clicking noise when heater is turned on
Does it do it with the A/C too?? If so it could be a broken fan wheel in the blower.. or a piece of trash in the blower housing.. like a leaf.. Post a comment so we know what you find..
2008 mitsubishi endeavor fuse box diagram
I have a 2008 Mitsubishi Endeavor. My son put coins on the lighter and after he put them inside i couldn't use it anymore. I don't know where is the fuse panel at?
Where is oil filter and
The oil filter is
underneath the engine passenger side, at the back of the air conditioning compressor
&&
The oil drain plug is under the passenger side of the engine, it is on the posterior-inferior portion of the oil pan.
Hope this helps
Positive Feedback ALWAYS welcome :)
Service light came on and
multicylinder misfire--get it on a tech II scanner and have a data stream read to pinpoint--look under hood for any flaws-think tuneup
Traction light, brake light, and tire inflation
these vehicles have a senser right in the wheel bearing (hub) the only way to fix the problem is to change the hub.when the brake light comes on it disables the traction control and that is why that light comes on a the same time.
Mitsubishi Endeavor Anti brake light stays on
hi
this maybe due to the brake switch being either stuck in or the switch itself has broken, if you look under your dashboard where the brake peddle is, you should see a black or white plastic thing being held to a small bracket, there should be a little plunger sticking out, if not, unplug the switch ( should be a 2 wire plug ) then undo the nut holding it in the bracket, and have a look and see if the plunger is broken or just stuck in, it could have some dirt holding it in place, just pull it back out and lubricate with a light oil, obviously if it is broken just purchase a new one....hope this helps please vote thanks
Not finding what you are looking for?