20 Most Recent
2008 Acura Tl Questions & Answers
Does the 2008 Acura TL have a timing chain or belt?
All the Acura motors listed in my book show a chain. The water pumps are driven by a serpentine belt. Water pumps only need changing when they leak out of the drain ho0le underneath or become noisy from failing bearings.
SERVICE DUE SOON LIGHT
Press odometer reset/adjustment shaft in, hold in and turn key to run position. Keep holding in the reset shaft in for about 30 seconds. release shaft. turn key off. restart car. Service Light should go off in about 5 seconds.
Faulty main relay
Order the main fuel pump relay from any Honda parts. Easy to replace. However, be aware that it might be the ignition switch, which is not difficult be not like the relay.
Car won't start
Sound like your timing belt. Take the top cover off, and see what shape that timing belt is in. If it's gone, i think you have anon interference engine, as most Hondas do, so replacing tghe belt and the timing belt components (idler pulley, tensioner and water pump while you're down there) will solve your problem.
I cannot get what I feel is a good firm pedal. I
i say you are wrong. if the brakes are hard, pumped 3 times
or more after engines stalls, that hydraulic system is not with air
when the booster is dead, the system reverses to 1929 brakes.
err 1965? with dual brakes......
so it's a booster /vacuum issue.
some booster need calibration, not just thrown on.
if you run all the FSM booster checks, read the FSM??????
Factory service manual???
worse of all , you never said why you were bleeding at all.
it just one day, got funky
it needed 2 year bleeding, (like i do)
you replaced something
did you read the pages on ABS and all the steps in bleeding
for ABS, some require a special scan tool.
RTM , no , read it twice.
did you get air in front of Mr. ABS modulator brick?
Reset service
makes no sense?
what in the world is wrong, my bla bla is messing up...??????????
what needs to be reset, NAME it, there are many possible.
RADIO
Nav
ECU/PCM/BCM/TCM
alarm
IMMO
what?
How to put the service light out
With ignition off, press and hold "select" and "reset" buttons, (the ones used for trip odometer). Then turn on ignition, but don't start car, hold until light goes out.
11/30/2013 10:09:11 PM •
2008 Acura Tl
•
Answered
on Nov 30, 2013
Not finding what you are looking for?