20 Most Recent 2008 Scion Xd Questions & Answers

in tank

no, first manufacture has tested and the tires that came with the car is the correct size, by adding a different tire, could cause lots of problems

First of all let me give u the exact specs of tires of ur scion xd.
Front Tire Size P195/60HR16.0 BSW AS Rear Tire Size P195/60HR16.0 BSW AS Front Wheel Size (in) 16′ black steel Rear Wheel Size (in) 16′ black steelTo purchase please refer amazon or ebay.

The fuel pump is located inside the fuel tank, the tank must be removed to access the fuel pump.

Inside the steering wheel the button for the horn has springs that can break or become weak when turning the weight of the air bag causes it to make contact and honk. The air bag will not deploy because of this but if you are planning to repair it be sure to disconnect the battery completely and wait ten minutes before attempting to disassemble the steering wheel. Failure to do this can cause the airbag to deploy possibility causing injury to yourself

A/F sensor circuit range/ performance malfunction [ bank 2, sensor1 ].. you can go to autozone and they can tell you where it`s at and cost. good luck..

best thing would be is to take the car back where you bought it and ask them

most all you need to do is open the back of the lights and install hid lights

any parts store can tell you what kind of filter you need for the car

this is a hard one, it means that possible you messed the chip inside it, when you replaces the battery did you use force to open, if yes that is when you may have damaged it, only way is to get a new key frob, and that costs

http://www.clubxb.com/forums/f28/mai...tml#post349637 this should help

most cap -- ie filter wrenches, use a 3/8 drive

under hood on passengers side,

possible window track that rolls it up and down, has broken, only way to find out is open the panel on the door and look

under the seat,

Hi Terry The firing order on the Scion XD 1.8L (2ZR-FE) 2008 is 1-4-3-2 Hope it helps

this took me sometime to figure out. but you have to turn the key almost to the on position, (one click before starting) and at the same time you press and hold the mileage reset button on the gauge for about 5-10 seconds.. you will see some lines appear when 5 small lines appear.. bam your done, turn key back and then start car,

on front, I put my jack near the frame member, on the rear it is the same, on the carrier frame