20 Most Recent 2008 Chevrolet Uplander - Page 9 Questions & Answers

It should be in the fuse block located on the passenger side of the dashboard. Open the passenger door and there is a cover on the end of the dashboard that you pull off. Try fuses 4, 8, and 24. Pull them out using the white fuse puller which is installed on the fuse cover. If the fuse is discolored, or the metal strip in the middle of the fuse (plastic part) is melted, then it is blown and should be replaced with the same number (amperage) fuse.

I just finished replacing mine.It is much easier if you do these steps:1. Remove the serpentine belt.2. Remove the nuts holding the main fuse box over the battery.3. Remove the reinforcing bar over the battery.4. Remove the battery.5. Remove the windsheild washer tank. 6. Now you have access to remove the pump pulley. Without removing the stuff, it may be possible, but it will be extremely difficult.7. Remove the pump pulley.8. Loosen the high pressure hose fitting.9. Remove the return line clamp.10. Remove the power steering pump mounting bolts.11. Remove the high pressure hose fitting.12. Remove the power steering pump while sliding off the low pressure hose.13. Remove the clips holding the reservoir on the pump.14. Remove the reservoir.15. Install new o-ring on the reservoir.16. Install reservoir on new pump.17. Install clips to hold reservoir on pump.18. Install new o-ring on high pressure fitting.19. Place new pump in position while sliding on low pressure hose.20. Loosely attache high pressure fitting.21. Tighten pump to mounts.22. Tighten high pressure fitting.23. Install clamp on low pressure hose.24. Install power steering pulley.25. Install washer reservoir.26. Install battery.27. Install reinforcing cross member.28. Install fuse panel.29. Install serpentine belt.30. Bleed the power steering system.

it takes 4.5 qts of 5w30

All a dealer has to do--- is pick the parameters or datathey want to look at & compare & turn on the record& play back feature,then drive the vehicle as you doWhen it acts up --they return to the shop & play back theinfo from the scan tool softwareNow you component testYou need an ASE Master-- Level 1 tech-- to do the diagnostics

Try holding down the power button, or removing the battery. Those are two suggestions.if it can't help you , diagnostic it if you need a diagnostic tool, click here: chinasinoy.comgood luck