20 Most Recent
2008 Chevrolet Cobalt Questions & Answers
My hazard lights wont turn
check the fuse panel for the emergency flashes and pull the fuse,, It probably runs more than just that one function, but at least you'll save the battery untill you get a new switch
How to reset tire pressure monitor on a 2009 chevy cobalt
Follow these step to reset the TPMS:
1. Park on a paved surface with no slope
2. Get inside the car and put the parking brake on
3. Turn the key to the ON position
4. Press and hold the INFO and RESET button together for a few seconds
5. Scroll and get to the tire service monitor menu and press and hold the reset button for three seconds
6. Go to the Tire Learn menu and press and hold the reset button until you hear two beeps and it will say tire learn ON
7. Move out of the car and start decompressing a bit-start from the driver side tire and move clockwise. The car will beep everytime it detects a change in tire pressure
8. All Tires will now register, and the digital display inside will tell you the exact PSI on each tire
9. Use a mobile compressor to inflate the tire to the recommended PSI or go to the nearest tire shop.
Reset oil life display after oil change in 2008 chvy calbolt
Turn key to ON/RUN with engine off
Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalize menu.
Press the information button to scroll through the available menu modes until the DIC display shows "OIL-LIFE RESET
Press and hold the reset button until the DIC display shows "ACKNOWLEDGED".
Turn the key to "LOCK/OFF".
Engine power reduced
Locate the IP to body harness connector, which may be located in and around the left hand kick panel area or inside the IP. Check to see if there is a water leak into the area and repair as necessary.
Not finding what you are looking for?