20 Most Recent
2007 Dodge Ram 2500 Mega Cab Laramie - Page 4 Questions & Answers
2007 dodge ram 2500 4wd 5.7 hemi. Changed the
Could be the master cylinder has gone, if you took the brake line off then you will have to bleed the brake system and that should fix it, you also need to backup and press the brakes so that the pads and piston seat into place but just go slowly and not very far, 10 feet maybe.
How do you check the engine code on an 2007 dodge
1.Get in the truck and close the door.
2.Turn the iginition key on and off quickly 3 times without starting it
3.Watch as the odometer numbers disappear and the error codes will show up.
4.When its done it'll say "done" and your mileage will return.
I have a 2007 dodge
You need to bleed your brakes, check for air in the lines making sure that you keep the brake reservoir full. Check for leaks from your master cylinder also.
Where is a/c filter located
They do not have an a/c filter. The mega cab does however have a screen on top of the hvac unit that is used for the airflow to the rear vents. The screen was removed in some cases to improve airflow to the rear vents. The instrument panel must be removed for access to it.
Need to change a head
i have never done one to be honest but i would imagine that you will need to remove the headlight to gain access as is common with a lot of new vehicles
07 dodge 2500 5.9 engine
Have you got juice in the battery and if so could be the starter or the alternator,is what charges the battery back up.
Drivers side headlight out on
There is only one fuse, but both headlamps are powered by the "Totally Integrated Power Module". It is located at the left front fender. If there is no power for High Beam or Low Beam, the module itself is probably at fault.
We have changed the bulb and the light wont
Most newer cars have this kind of fuse system built into them. Only way to reset it, is to disconnect the battery under the hood, and reconnect. Please let me know if this works, and rate me. Good luck!
How to turn off Check Engine Light 2007 Dodge Ram
YOU HAVE TO TAKE IT TO A SHOP AND HAVE IT SCANNED, OR FOR ABOUT THE SAME PRICE AS A SCAN YOU CAN BUY A CODE READER AND CLEAR IT YOURSELF. THAN YOU WILL HAVE THE TOOL FOR EVERY CAR BUILT AFTER 1996. YOU CAN BUY THEM AT WALMART OR MOST AUTO PARTS STORES.
Not finding what you are looking for?