20 Most Recent 2008 Ford Crown Victoria - Page 9 Questions & Answers

`Get the wiring schematic of the 2008 crown vic and the schematic for the radio from the donor vehicle, look for the radio wiring in each schematic and hok up accordingly.

tengo un crown victoria 2001 lo encendi y al intentar hacer el cambio se apaga y se encienden las luces delanteras, que puede causar esta falla ? gracias.

if we are talking bout dash illumination, park lamps and headlamps i would check the multifunction switch first

Bad ignition coil on cyl 8

I've never heard of a rear-end alignment on a Crown Victoria. The car is a rear wheel drive which means it has a solid rear axle assembly in it. The only way to get a rear-end alignment is if your vehicle has an independent rear suspension setup.

Turn the car on?

the alarm is preventing the car from starting. it is part of the antitheft feature. disarm the alarm. when the light is off it will crank

When temp light come on the engine is overheating

Here's a link on Steve McQueen. Steve McQueen Wikipedia the free encyclopedia

check the fuses

Have battery load tested.

This should be pretty straight forward, except that depending on year model you may need to disarm the airbags to be safe. Start by removing the inner fender (not absolutely required but helps I think), then bolts in headlamp area, then bolts hidden between door and fender which you get to by having the door open, then bolt at bottom edge of fender, then bolts along top edge of fender, then two or more right in cowl area, and carefully lift off, making sure to retain any shims you find which were used for alignment. Tape these and mark their location for reuse.

I imagine you've found it by now. If not, write back and we'll try to find it.

I'm not familiar with any reset button, but I would check for an ignition fuse first. 10-20 amps

when in the driving seat the bank 1 is on your right hand side bank 1 has cylinders 1,2,3,4. 1 being close to the headlights, bank 2 is the left hand side 5,6,7,8. 5 being close to the head lights. I am not sure the but I think the firing order is 1,3,7,2,5,6,4,8

Transmission is bad. Take to Transmission shop. Perhaps buy one out of the boneyard and have them put it in.

just asking, have you checked the fuse and the lamps/

this sounds like your temp mode actuator is stuck . if you have autotemp control your part no. is YH1766 for the actuator ! Good luck !

Sounds like possibly a cracked intake manifold.need to pressure test it to see where the leak is

Blown fuse on brake light switch or one of the wires going to the brake light switch is broken.