Top 20 2008 Nissan Sentra Questions & Answers

Fob batteries must be 3.2 volt reading and have no visible marks on the surface, indicating poor contact. Replace batteries

P0845 NISSAN - Transmission Fluid Pressure Sensor 'B' https://www.autocodes.com/p0845_nissan.html

Try this link for all types of radio codes sent to you: Car radio codes in Uxbridge London Gumtree

You have to take it to the dealer and they have to change your ipm computer board. They'll probably have to order the computer part and replace it. bring both of your keys in when you pick up so they can re-program them. This part will clear out your keyless remotes.

Here's a video on replacing your headlights. Headlight Change 2007 2012 Nissan Sentra 2008 Nissan Sentra 2 0L 4 Cyl

Post the codes...

Are you a thief? If not, go to your Nissan dealer with proof of purchase etc , identity documents and get a key.

OBD is the On Board Diagnostics. The codes are generated by the ECU or the Engine Control Unit, the ABS system, the BCU, and the SRS system also generate readable codes, but most readers are unable to access this data.

Hi Steve,here's a link on your timing belt. Repair Guides Engine Mechanical Components Timing Chain Front Cover Seal...

need to remove the ignition coils from the top of engine then remove the spark plugs

Have the Mass Airflow Sensor cleaned

Now you learned about removing battery cables, for no reason Look in your owners manual for the next step you take After that --you will need to call a dealer or repair shop & have them look up what --you needed to know before you ever remove a battery cable

Is the MIL (check engine light) on? Need info people

which one

unlikely unless it is not tensioned enough and the alternator charge rate is not sufficient to run the electronic properly. More likely something to do with what has been recorded in the fault codes so check them out .

under the steering column left side

driver side need to remove panel door trims to remove the connections and the switch itself

Make sure the steering wheel in not causing a bind in the key switch. If the steering wheel feels like it is stopped in one direction, try pulling lightly in the other direction. With the key in the lock, it should turn a slight amount in either direction. If you need further help, reach me via phone at https://www.6ya.com/expert/tom_1788908372a4836f

fuse is under steering wheel left side

Open up the hood and on the top of the lens assembly will have a couple of screws holding it in. Remove or loosen them and pop out the lens assembly from the front. Once the assembly is out you can easily remove and replace the bulb.