20 Most Recent 2007 Chevrolet Impala LS Sedan New Cars - Page 2 Questions & Answers

7E8, 7EA. Cat failure. - Check the health of catalytic converter. - Check for cracks in muffler. - Check air leaks. - Check back pressure of the tail pipe.

I went to get in my car tonight to leave and my console gear shift would not shift out of park. The gear shift button will not press in. Absolutely nothing! I have a 2007 Chevrolet Impala. Anyone know of this problem and what is the solution?

Did you replace radiator cap? Maybe air in the system?

there is a fuse for the windshield washer pump. It is located in the under the hood fuse box.The fuse is near the bottom marked WSW. Look in the manual for fuse box (under hood) I read that Chevy recommended repacing the 10 amp fuse with a 15amp. There are spare fuses in the bottom of the fuse box(labeled in the manual) and there is a 15 amp. I changed mine in 3 minutes and now it works. Hope I helped.

it might be in your ownersbook or the dealers parts dept can help or google it

Fast flashing dash signals mean there is a bulb issue-DEFINATELY!

Best Manuals for easy and best solution go to this link

That car uses Dexcool

It is a 2 speed system that utilizes 3 relays to do this.

check the fuse

check for a light fuse problem

Normally there's diagram under hood area, sometimes near radiator shroud, or on belt cover area, or in owner's manual. If not do a google search by engine vin letter # or size for drive belt routing. Autozone has some online diagrams, also.

In regards to what? Are you having a random no start issue with a blinking pass lock light?

YOU'VE A CHEVROLET DEALER QUESTION OR A TRANSMISSION GARAGE QUESTION

You'll need to remove your power steering pump to access the sensor. Remove the small bolt holding the sensor located right in front of the intake manifold for 3.5 and 3.9 engines. Good luck

On the passenger side. Look at the wheel well and find the oil filter. The sending unit is just above it.

have you check the purge valve, and your vacuum lines? here's a vid you might want to check out:https://www.youtube.com/watch?v=AlfOSMmisPg

on brake peddle u have a sifter release switch,,no working

These bulbs are replaceable, however, the cluster must be removed to do so. It is usually held in place with four screws and the trim/bezel may have to be removed to access these screws. Once removed, the cluster will pull out and the bulb can be changed

To remove the rear seat, pull up on the front of the seat bottom, it should be hooked in place by spring type clips. After you get the front edge up, pull out the seat. This should expose the bolts/screws that hold the seat back in. Look below and there should be a couple of screws holding the seatback to the car body. Remove these and then you can pull the seat back out of the car.
K