20 Most Recent 2008 Jeep Liberty - Page 6 Questions & Answers

Sounds like a fuse problem.or connection of some type. The main plug in at the back of the dash board supplies everything...Check your owners manual that came with the car. Check what it list under fuses inside and under the hood PDC box next to battery....

I don't list a mass air flow meter for a 3.7 engine. At least not a sensor you can get from an auto parts store.

have a load test done on the original battery as it appears that you have a shorted cell that is draining all the power from the jump battery.

Unit has a draw somewhere that needs to be addressed. I have found the auto starts sometimes can cause this. But if the draw is through the negative side it could be tough. You should take it to the dealer and have them perform a draw test on the entire vehicle.

google jeep libery forums find one or more join and post this question therethan come back here and tell everyone who is asking questions on here to just google the kind of car they have followed by forums and get all there answers therethats what ive done 65 times so far tonite and its getting tiresome

answered

join a jeep forum they can be found by googleing, jeep liberty forums

Hi there:Actually the digital display was saying GAS CAP. Either the gascap was left loose or it has a leak in the gascap or fuel neck area.Your vehicle is still under factory warranty. You get three years or 36000 miles, whichever comes first. I highly recommend you bring it to your local Jeep dealership for the transmission issue.Hope this helps.

I would check the battery in your car remote . I had the same issue where if the remote was within 50-70 feet from the car my doors would lock or unlock and sometimes the remote start would turn the car on randomly. The battery was my cure.

Unhook the battery for two minutes on the negative side,then hook it back up. It will take a complete drive cycle for the computer to "relearn" everything,which takes between 45-60 miles of driving.

stop driving check oil to see if there is water in it if so you have a bad head gasket or cracked head