20 Most Recent
2007 Jeep Wrangler Unlimited Rubicon 2 Doors - Page 2 Questions & Answers
REMOVING STOCK SHIFTER FOR 4X4 ON 07 WRANGLER
The 4WD shifter knob on the 2007 JK's is ridiculously hard to remove. Pull straight-up with all your might, then after that fails, get some towels, and a chunk of would with a long pry bar. Hopefully you won't crack your center console.
5/19/2014 1:17:12 AM •
2007 Jeep...
•
Answered
on May 19, 2014
Abs light stays on and the esc indicator light also but when you start it it shows it off
the operators guide shows what these mean and what to do.
lost that>? i have one, and 08 JK.
pages 105 to 116
it resets each drive. the opr guide says that, and does.
its a very complex system, you should RTM.
ill quote your missing pages.
ABS:
If the light remains on after start-up or comes on and
stays on at road speeds, it may indicate that the ABS has
detected a malfunction or has become inoperative. The
system reverts to standard non-anti-lock brakes.
ESP:/TCS
The ESP/TCS Indicator Light (located in the instrument
cluster), starts to flash as soon as the tires lose traction
and the ESP system becomes active. The ESP/TCS Indicator
Light also flashes when TCS is active. If the
ESP/TCS Indicator Light begins to flash during acceleration,
ease up on the accelerator and apply as little throttle
as possible. Be sure to adapt your speed and driving to
the prevailing road conditions
is this clear? if not ask more, questions , more specific and we can peel the onion deep as you want.
also wiki this topic, to understand it ...
3/8/2014 8:13:58 PM •
2007 Jeep...
•
Answered
on Mar 08, 2014
I own a 2007 jeep
I had a similar issue where the alarm went off, pulled the battery to silence, and upon re-connecting it the Jeep wouldn't start. It's a protection mechanism built into the security system to prevent tampering/bypassing the system. The computer goes into lockdown and won't start...
To clear it you have to reconnect the battery and leave it sit. It's supposed to be a 60min cycle, but it seemed like it took longer for me. I plugged it in before leaving for work (in my wife's vehicle) and she tried starting it several hours later when she needed to run an errand and it started right up.
2/18/2014 7:36:53 PM •
2007 Jeep...
•
Answered
on Feb 18, 2014
Jeep wrangler 2007 door hinges
I have removed the doors on my 2007 JKL several times and there is only the retaining nut, and grease in there. That's it.
Maybe there is no grease left in there?
Try spraying WD40 into the hinge over a few days, then disconnecting the electrical harness for the door, then remove the retaining nut from the bottom. Then get a muscular friend or a floor jack and piece of wood to slowly lift the door out of the hinge. Grease it well before you re-install the door. Reconnect wiring.
1/2/2014 4:40:57 AM •
2007 Jeep...
•
Answered
on Jan 02, 2014
Not finding what you are looking for?