2007 Nissan Quest 3.5 Minivan - Answered Questions & Fixed issues
SERVICE ENGINE LIGHT P0462
the 05-07 nissan quest has a problem with code p0462 fuel level sen/circ (low voltage) . In past 6 months if serviced 10 van with this issue, and found according to service manual that the tank sender unit is at fault. This has not fixed the issue, and the cluster self test/data montitor values show to be in specs. swapped cluster out of known good van has fixed this issue everytime . the cluster is nearly 400 bucks . You can have yours repaired !! ck online .
3/12/2023 6:16:46 PM •
2007 Nissan...
•
Answered
on Mar 12, 2023
•
2,031 views
Red "Brake" warning light stays on anytime ignition is on.
Having the vehicle hooked to a scan tool to check for DTC'S - diagnostic trouble code's ,an input data to instrument cluster . Some of these ABS systems need to have a factory or professional type scan tool hooked up to cycle the ABS pump to bleed the air out . Your best bet ,take it to a qualified repair shop .
12/8/2017 8:09:21 PM •
2007 Nissan...
•
Answered
on Dec 08, 2017
•
598 views
Need know where expansion valve is on 2007 nission quest
Have you checked your system pressure? Are you sure that it is kicking out for high pressure? and not low pressure and just need a bit of charge? If it is kicking out on the high side for a clogged expansion valve you have to remember that an A/C system is a sealed system, if there is debris inside of the system and has clogged the expansion valve that there is only once place for it to come from and I would expect to be changing the compressor soon.
6/28/2016 12:40:09 AM •
2007 Nissan...
•
Answered
on Jun 28, 2016
•
125 views
Nissan quest drives like in low gear
I would hazard a guess that you have a multiple cylinder misfire and your vehicle computer has gone into "limp mode" prevent further damage feom.happening to the vehicle.
1/13/2016 5:07:43 AM •
2007 Nissan...
•
Answered
on Jan 13, 2016
•
204 views
Horn not working 2007 nissan quest
- The horn could be unplugged or the connection could be dirty.
- The wires in the leading to the horn could have been damaged.
- The fuse could be bad. Check the Owner Manual to see which fuse and check it. Usually the horn is on a fuse with other devices. If the other devices are not working as well, then the fuse is a likely suspect.
- Rarely, the horn itself is faulty and needs to be replaced.
12/16/2015 10:38:41 AM •
2007 Nissan...
•
Answered
on Dec 16, 2015
•
3,461 views
My radio just stop
Look in owners manual and find diagram of fuse box location, and fuse functions. Look for fuse blown that is listed for radio, or any other dash function. The manual usually lists exactly what function each fuse is for but sometimes a fuse listed for "accessory", or other function, can cause the radio to not function.
2/24/2015 2:06:10 AM •
2007 Nissan...
•
Answered
on Feb 24, 2015
•
38 views
One day TPMS sensor light was on on my instrument panel so I went to the repair shop so they reset it with the diagnosis machine and the sensor light was gone from the instrument panel temporarily. Th
The TMPS device in the tire attached to the wheel once introduced to the TPMS computer receiver it continuously checks air pressure and sends that info to the reciver (each whel does this) the reveiver compares the pressure data betwen the 4 wheels. If they are not the same it will put up a message to the dash TPMS icon.
So if all of your wheel sensors are sending messages and you are getting a message tire low -- they are working.
If you simply get the TMPS symbol or lettring and it is only becuase of one wheel -- replace the wheel sensor.
If all wheels are not working (each one off and on) then have technician remove the the electronic hadnshake for the car to the 4 wheels and then reintroduce the wheels to the car. If that fails then have the revieving computer check for faults and replace or replace it.
Note the wheel sensors each have a battery -- hence the batteries can go dead. Some sensors can have the battery repplaced. It is recommended that all 4 be done at the same time.
12/27/2014 9:18:55 PM •
2007 Nissan...
•
Answered
on Dec 27, 2014
•
375 views
Need to remove the front bumper
I have two older cars than yours and I just polish the lens with a gizmo that attaches to my cordless drill and plastic polisher. They come in kits at Walmart and other places.
11/26/2014 3:15:32 AM •
2007 Nissan...
•
Answered
on Nov 26, 2014
•
213 views
Not finding what you are looking for?