20 Most Recent 2007 Nissan Quest 3.5 Minivan - Page 8 Questions & Answers

This is most likely the O2 Sensor however, that light may also come on for a vacum leak or anyone of a number of other sensors. Take the vehicle to Auto Zone and ask them to use a code reader on it and tell you what the code is for. If the code is for O2 sensor as I suspect the part will cost about $40 and take maybe 20 minutes to replace your self. ($40 for part + 5 to 10 for the special socket) If it shows anything else you may want to take it to a mechanic to have the vehicle diagnosed.

interior lights are controlled by the fuse box in your car... your tail lights are controlled by both the fuse box inside the car and the one under the hood

sounds like a blown fuse , some tims the tail lights are on a fcircut by themselves or with small circuts like dash lighting, check all fuses both in vechile and under hood.

Head up to a local parts store and have the OBD Codes read with a diagnostics code reader and post the results.

Threre are so many things, this will help narrow it down, and i can give you a proper fix - instead of guessing.

The code(s) should be PXXXXX (where X= numbers)

Thanks!!

http://www.popularmechanics.com/automotive/how_to/4213448.html

go here and follow the instructions and thats the best way to bleed the brake system

1. its located where c is

Either it has rusted up or the mechcanisim has been bent,take door panel off check it out if rusted use some wd40 work lock untill it moves.

It still should be under the manufacture warranty of 3 year 36,000 miles. Which is bumper to bumper coverage. The engine and drivetrain are covered under 6 year 60,000 miles.

Your best bet is to have it towed to the dealer. Warranty will also pay for your towing fees.

There is a wiring problem on your drivers side passanger door switch.

I had the same problem but just did it tonight. I found the solution on another site online. You basicallly just have to jiggle the assembly around and pull backward (away from the rear of the car). Don't be afraid to pull hard, you won't hurt it. In addition to the two bolts you have to remove, there are a couple internal plastic clips that hold it in place.

Only problem is, I replaced the bulb and the brake light still doesn't work... Might be a fuse or something, but I think I'll throw in the towel and take it in and stick to my day job--pushing a pencil and working a pc.

Good luck.

put your socket in hold from on top take a hammer or o heavt object and knock it til it comes loose. if that doesnt work buy a spray a a hardware store that loosens stuck bolts

you can go here.

I am 4 months late, but here goes , one more HUNT engine question. if you try to buy one ,none are sold, so where'd you put it if can't buy one, now that is the $64,000 question, no problem told at all just a hunt, endless here, is engine power lacking and some dweeb said find the MAP that does not exist, why you posted? YES! one more useless hunt. yes this engine has MAF< (air meter) not a baro map sensor. the mAF is just behind all air cleaners. just there. no country told. no engine told (yes for USA cars below) that sensor is only used on engines that must have one. 1/2 do and 1/2 dont; but not one clue or VIN number of car told map can also be for EGR only testing,(OBD2 USA) the map has vacuum line or intake manifold port mounted, if not seen there it is NOT THERE. (and is not there) Gen 4 quest , USA I only do USA answers. our car has this v6. only 18,000 made (rare) VQ35DE 3.5L V6 my wild wild guess, engine power lacks.? check all fuses first and scan the PCM 2nd? now that matters., 1: bad engine. (cam VVT or chain guides dead?)low compression. 2: bad spark, bad COP coils and spark plugs bad, 100kmile life. 3: bad fueling too much or too little, fuel pressure dead wrong bad FPR bad, or bad MAF. EGR valve stuck open. gross vacuum leaks there are 20 test to do with 20 tools and meters, post real problem and we work that to the end using tools.

Nothing specific to the Quest, but there are two videos for other models https://www.google.com/search?q=2012+Nissan+Quest+replacing+tag+lights ..

no ecm wont adjust it will be setting off more codes and stalling the egr can also cause a no start problem need to fix and hook the egr correctly

check fuses and relays --horn switch --clockspring --wire harness

not much info hear But 1 of the first things to check on any car not running right is the Air Filter. because your car has to breath to run right. if you hold the filter up to the sun you should be able to see the light through filter. it is almost impossible to clean most filters. if any questions just replace air filter! same with fuel filter. you did not say if your check engine light is on? if it is most any auto parts will put a scanner on your car for Free and print out the codes if you ask. 1976 or newer. good luck

The EGR valve might be build up with a lot of carbon I would clean it first if the code comes back then I will replace it