20 Most Recent
2007 Nissan Frontier SE Crew Cab - Page 6 Questions & Answers
Where is the fuel pump
- The fuel pump relay is about the center of your dash (underneath). There is also a fuse in the fuse panel, under the dash, drivers side. Should be 15Amp.
Regards,
Tony
How do I change the
The interior cabin-air filter is accessed from behind the glove box. Open the glove box door and check for a removable panel, which accesses the filter. If that is not sufficient, the glove box may need to be removed, usually two 8mm screws, or two Phillips head screws is all it takes.
My husband hooked fog lights up and used the brake
Check the brake light bulb.The bulb can get short.Check the bulb,many a times the internal bulb filament gets short,while removing and reconnecting the wires.
------------
Also as you mentioned that switch is replaced.So with meter check the voltage at switch.Apply brake pedal and see,if there is voltage at switch.Its a 12 volt part,check the voltage at switch.If there is no voltage then its loose connected switch or faulty switch.But if there is voltage to switch connections then,switch is connected fine,but the problem is between the bulb socket and switch wiring.Check the voltage at bulb socket wiring.There will be short.
--------but if there is voltage at bulb socket wirings and bulbs are checked out ok.Also the switch is showing proper voltage.Then it can be shorted/blown fuse in the fuse box.The fuse box under dash in the instrument panel.Check the fuse in fuse box.For exact location of fuse box and how to by pass the fog lights to work with brake/tail lights.Please click on the link below:----
http://technoanswers.blogspot.com/2011/02/how-to-bypass-your-fog-lights-on-nissan.html
-----------------
This should help,keep updated.Thanks.Helpmech.
Speedometer and the odometer stoped working, will
If vehicle speed sensor is replaced.Then its quite possible that the problem is with instrument cluster.The circuit board of the instrument cluster is got short and it needs to be repaired or replaced.In some cases repairing is not possible,due to major short in the board and the cluster needs to be replaced.
----------
You can try doing this repairing.If you are familiar with how to use soldering iron and meter ,you can do this repairing.To repair the instrument cluster board.You will need to remove the cluster out of the dash.To do this,this is the procedure as follows:----
You have to remove the clack bezel that surrounds your AC controls and runs all the way around the top of the dash.. two screw under the bezel just below the AC controls and one (I think) on the other side of the dash. There are two screws in the inner bezel that face upward toward the top of the dash. You have to take out the three screws that hold the plastic housing the encases the turn signal, head lamp switch, steering column and slide the rubber ring off the ignition switch. Once you get the inner bezel off and the top plastic cover off the steering column you will see the two top screws that hold the cluster in place. You may need to push the manipulate the top of the column cover to expose the two bottom screws for the cluster. Once all are out the cluster will pull forward. You will need to unplug the Molex style connectors by squeezing down on the small latch that is top center.--------Now you can see the cluster board and its connections.First see if you can see any burnt wiring on the connection.If you see,then the burnt or loose wire is the cause of the problem.You will need to connect external wire to fix this issue.But if the wires are clean and intact then check the tiny components on the cluster board and you will see the burnt components easily and remove this component with soldering iron and in the same way fit replacement components.This will solve the problem.The components are easily available at electric parts store or at www.radioshack.com --------
If you are not familiar with repairing then ,there is online site who deals with this repairing .To get it repaired there.Click the link below:---
http://www.mrwhizard.com/
------------------
This will help.Thanks.Helpmech.
I changed tires on my 2007 frontier... they have a
Use the listing on the door jamb, not the side of the tire. If all are ok, then one of the sensors may have been damaged when replacing the tires? Be sure the spare is OK. some spares will have a sensor.
My 07 Nissian Frontier Heater is
probably a bubble of air in the system that hangs at the heater hose until pressure from water pump increases. Park on an incline to help the bubble migrate to the radiator. Open radiator cap, start engine and let it warm up until thermostat opens. after water is flowing in, fill radiator all the way to the neck. watch to see if bubbles continue to come up after the level stops going down, as this would indicate a blown head gasket. If bubbles stop, close cap and you should be good.
I have a problem with my fuel gauge. Do I need to
Usually you can get a fuel level sensor seperately from the pump. I would call a parts warehouse and nissan to check. If it doesnt come seperately then you will have to buy the whole assembly. (Fuel pump, housing, and sensor included)Some shops will charge you 2-3 hours labor to fix plus whatever you agreed for diagnosis, anything over that is too much. Dropping a fuel tank usually isnt a hard task especially if they drain the tank before they take it out.
Fuel sensor is not working properly. fuel gauge
NHTSA 10V075000
Feb 26,2010
Units Effected 80689
Fuel System, Gasoline Storage Aux,Tank
Nissan Is Recalling 2006 thru 2008 Frontier,Exterra and Pathfinder Vehicles
for deformed molded fuel tank,causing fuel gauge to show one quarter tank
Dealer will replace fuel sending unit with modified float arm
Recall to begin March 22,2010
www.nhtsa.gov
A light came on in
it's the park brake light. it comes on telling you when the park brake is ingaged. there is a wire on the park brake thats of a low gauge it may have broke or the brake is slightly on
The driver's window won't go
Electric? Usually the motor, but with a volt meter you can see if you have voltage and a ground at the motor harnes while moving the window switch. Then you will be sure.
2008 nissan frontier oil filter location
Look under the front of the truck. You will see a square removable plate with 2 bolts in it...inches from where the radiator sits. Remove those bolts and you will have access to the filter.
Not finding what you are looking for?