20 Most Recent 2007 Nissan Frontier SE Crew Cab - Page 2 Questions & Answers

ROCK THE CAR BACK AND FORTH.

What is a "presser sincer"? Do you mean pressure sensor? What pressure sensor are you referring to: brake, A/C, ABS, fuel vapor, OCS?

AND? What are you asking for a step by step how to do it guide. If your a DIY'er please reconsider as it is a job for persons with advanced know how only.

Most likely the e-brake cable is frozen either the one leading back from the handle/pedal, or the two cables that split and go to each individual wheel.

Not sure about the 2007 but in an earlier one I owned there was a key-slot opening above the rear bumper (and below the tailgate) that you put the jack handle into and cranked it down using the chain lift mechanism that was built into it.

Your Transmission is going bad... My Son's Pathfinder has the same transmission and they are telling him $5,000. The TCM is internal of the Transmission. We have contacted NISSAN and the BBB but they are no help. The ECU also has a problem along with the IAC.. Good Luck

not many major parts are compatiable . After market warehouse may have parts or failing that try auto wreckers.

Depending on the sub-model, 2005 - 2012 versions *can* fit. Look for yours in the list below:

• Fit note: Crew Cab Pickup, Extended Cab Pickup

This product fits the following Nissan Frontier submodels

• 2013-2013: Desert Runner; 6 Cyl 4.0L;
• 2011-2013: S; 4 Cyl 2.5L;
• 2011-2013: SL; 6 Cyl 4.0L;
• 2011-2013: SV; 4 Cyl 2.5L;
• 2011-2013: SV; 6 Cyl 4.0L;
• 2009-2013: PRO-4X; 6 Cyl 4.0L;
• 2011-2012: S; 6 Cyl 4.0L;
• 2008-2010: SE; 4 Cyl 2.5L;
• 2005-2010: LE; 6 Cyl 4.0L;
• 2005-2010: SE; 6 Cyl 4.0L;
• 2005-2010: XE; 4 Cyl 2.5L;
• 2005-2008: Nismo Off-Road; 6 Cyl 4.0L;

When calling to inquire or order - tell them the year, make, model (S, SL, SV, LE, SE, XE, etc.) Cab type (crew, extended, etc.) before paying. Have a look at the link below. 2005 2012 Nissan Frontier Tail Light Replacement Driver Side...

You will need a 12 mm wrench and socket, a 10 mm socket , an extension and the socket for your spark plugs, and an intake plenum gasket. Start by pulling the positive cable from your battery. Next pull the intake cover off the top of the motor. On the drivers side you will see 3 coil packs or "cops" ( coil on plugs) those have two 10mm bolts, one on each side. Remove those , pull the coil, unscrew your spark plug with your socket, and replace. On huge passenger side you will have to remove the upper intake arch (plenum) to get to the remaining three plugs. Repeat process from the drivers side. !!!!replace your intake gasket when you remove the upper plenum or you will have a vacuum leak.

You need to set all the pressures to 35 psi. first then drive for approx.1/4 mile. If this doesn't work to reset the light (keep in mind the code itself will still be stored even though the light goes off) you will need to take it to your Nissan Dealer to have it scanned as there may be a malfunction with the sensor. If faulty and you are under 36k miles then it should be covered under your factory warranty. Hope this helps.