20 Most Recent 2012 Ford Edge SE 4dr SUV 3.5L V6 6-speed Automatic - Page 6 Questions & Answers

Unless it was raining out and there's a leak in your windshield, is it possible that the heater core sprung a leak. If it is the heater core, the "water" would be coolant (antifreeze). If it is plain water, it is the resulkt of a leak between the passenger compartment and outside - the windshield is the logical cuplrit.

Put a good battery in it.

what are the codes coming up

Was the flush done in a shop,and if yes. most shops do back flushing causing things to close,and block up. where is it leaking from.

you should take the positive battery cable off for a full minute that should reset your computer in your vehicle it will also reset your radio or clock

If you swerve the car back and forth and the sound dissapeers when swerving to the left( reducing the weight on front left tire) this could indicate a wheel bearing problem

1 Disconnect the negative battery cable from the battery using a 1/2-inch wrench. The battery in the 1995 Mustang is located on the driver-side of the engine compartment behind the headlight assembly. Wait 15 minutes to allow the residual charge in the air bag system to discharge and the air bag system to be disabled. This will prevent accidental deployment of the air bags.

2 Remove the steering column trim cover screws, located on the bottom of the steering column cover behind the steering wheel, using a screwdriver. Lower the tilt steering wheel fully. Unsnap the two halves of the trim cover from each other and remove them.

3 Turn the ignition key to the run position. Insert a 1/8-inch punch into the small retaining pin hole, located below the lock cylinder housing, and depress the retaining pin. Slide the old cylinder out of the housing.

4 Turn the key to the run position in the new ignition lock and insert the new ignition lock into the housing. Turn the key to the off position to lock the new cylinder into the housing. Turn the ignition key to the off position and pull on the ignition lock to verify it is securely installed. Reinstall the steering column trim covers. Reconnect the battery and tighten the cable clamp bolt securely.