20 Most Recent
2012 Buick Regal GS Sedan 2.0L 4-cyl. Turbo 6-speed Manual Questions & Answers
The correct crank pulley puller for a 1995 Buick Regal Custom 3.8
Using a standard harmonic balancer puller with 3 bolts that are just a bit too large for the 3 openings if possible., Tap them with a die large enough to get a decent grip with the bolts and remove it like any other. If that won't work then just drill and tap 3 holes for the remover. I generally use 10 MM bolts when I do mine.
2003 buick regal where do the wires go to for fuse #3and#7under the hood fusebox
This link might help:https://www.google.com/search?q=2003+buick+regal+where+do+the+wires+go+to+for+fuse+%233and%237under+the+hood+fusebox&tbm=isch&ved=2ahUKEwjUusDAi7byAhUBYTUKHRClBGAQ2-cCegQIABAA&oq=2003+buick+regal+where+do+the+wires+go+to+for+fuse+%233and%237under+the+hood+fusebox&gs_lcp=CgNpbWcQA1D1vRRY9b0UYJLDFGgAcAB4AIABiwKIAYsCkgEDMi0xmAEAoAEBqgELZ3dzLXdpei1pbWfAAQE&sclient=img&ei=a6MaYZTZAoHC1QGQypKABg&bih=625&biw=1366&hl=en
1996 Regal GS 2door drivers side floor gets wet after a rain.
Body leaks can be a nightmare to find as the ingress point is sometimes well away from the wet spots.
Door seal, sun roof, sun roof drain(s) and windscreen are the most common ingress points though sometimes a blocked heater drain can cause a flood especially if the car is not parked on level ground.
2011 Buick regal heated seat repair
There are bulletins for this. Do ohms test on heating element. The bulletin mentions a couple of codes, B2425 and B2430. The bulletin mentions modules were replaced as a fix and nothing wrong with modules.
2003 BUICK REGAL CIGARETTE LIGHTER
If you have a test light we can narrow this one down.
Turn the ignition to the "run" position.
With the cigar element removed, ground your test light, make sure it is a good clean ground, no paint or plastic, carefully stick the tip of the test light probe into the lighter housing (DO NOT TOUCH THE SIDES OF THE HOUSING, your fuse will blow) and touch the center contact tip of the housing, the light should illuminate if there is power to the housing.
Let me know and we can go from there.
Regards,
Not finding what you are looking for?