20 Most Recent
2001 Toyota Yaris - Page 8 Questions & Answers
Heater in my car blows slightly worm air
no year stated. nor engine.
the engine must be 180F or more and hold
we use what is called a tool, called a thermometer,
we measure the engine heat first. at the thermostat housing
180F is typical. if not fix that first.
check fuses if the fan "blower" is dead , is it?
blows cold in all lever positions? hot + recirc, + defrost ,high or low vents?
all vents cold? (warm)
The causes of crashes speedometer Yaris 2008
please post a real question.?
the speedometer never causes crashs
only the part between the ears
and pure raw fate (ice, tree falls on you, etc)
never driver faster than conditions permit. (same on a bicycle with no speedo at all or a skate board)
Losing all power
no year, ?
is this 1nZ engine?
check all fuses yet.
did you connect a scan tool yet, and look?
Toyota Yaris D4D Problem Scanner P0388
wow, no year car, nor engine type. stated.
does engine run? this is first ,no?
how many miles on it, 50k, 300K? what?
has the cam change been making noise for ever?
it means the input signals from that sensor is bad.
that means its bad or the wires connecting it are bad.
1nz-fe engine? 1.5L
if rpm is limited to 3000 rpm the ECU is in limp home mode.
no other codes, does it run at all ?
388s,
the ECU brain, what it means when 388 are thrown.?
it means the ECU thinks the engine is spinning but
the Crank sensor is producing odd signals.
since you failed to say , if engine runs or not, i must guess.
it can also mean the Cam sensor is not agreeing with the crank sensor.
1: sensor dead. (wires first)
2: sensor misfiring (wires usually)
3: The ecu can report 1 misfire in 10 from both sensors !
crank pulley is right side of car
facing it, the sensors is at about 7PM
check wires there.? yet?
post more facts and we can do test.
top fact, does engine run and run right>?
Eml light on on yaris
-Have some one to scan the code for you. Then what is the code
indicate or what kind problem.
Good Luck
Mai
Google com
Did you replace the bulb and at least clean the electrical contacts in the bulb socket?
Not finding what you are looking for?