20 Most Recent
2010 Toyota Camry LE Questions & Answers
Signal ABS on
plug it with diagnostic to get true picture and also check brake swith on brake pedal
P0017 error code
crank shaft sensor , get the code cleared and see if it comes back , if does then more invetigations will be required , are there any running problems ?
Replace windshield washer pump
the washer pump is located in the bottom of the washer fluid bottle , so where you top up the washer fluid that is where you need to get to they are usually accessed by removing the wheel and inner wheel arch liner then the pump can be pulled from the fluid bottle
What should my 2010 camry rpms be at in park starting the car
Hi Joseph, When starting the vehicle from cold in cold weather, the RPM can be as high as 1300 and in temperate climates about 1100 RPM. The RPM will drop to normal as the coolant is warmed. Normal idle speed is between 750 for Auto and 650 to 700 for manual transmission. Regards John
Abs light on after after rear struts replace
The ABS light being on is most likely the wheel speed sensor, the wheel speed sensor is still 100% good, it's just that someone didn't remove the sensor before working on the strut, so when they pushed down on the lower control arm or knuckle they ripped the 20-24 Gauge wire apart, you can buy a new harness or splice it back together and use heat shrink to hold it.
Not finding what you are looking for?