2006 Toyota Avalon XLS - Answered Questions & Fixed issues


It sounds like you have a dead or defective battery or corroded battery cables or both. Have th battery tested at Autozone or a parts store near you, it is free.

2006 Toyota... | Answered on Jun 01, 2016 | 31 views


There is no fuse that is isolated purely to the speedo on that vehicle.

Contact Toyota service because there will be other owners with that vehicle who have had the same fault that they will have dealt with.

2006 Toyota... | Answered on Jan 11, 2016 | 201 views


Need to know year make and model and what's happening to make you think it needs fixing

2006 Toyota... | Answered on Aug 15, 2015 | 37 views


There is a Toyota Technical Service Bulletin issued for this:-
T-SB-0291-08 September 11, 2008 2GR-FE Valve Timing

Procedure Service Category Engine/Hybrid System Section Engine Mechanical Market USA Applicability YEAR(S) MODEL(S) ADDITIONAL INFORMATION 2005 - 2009 Avalon 2007 - 2009 Camry VDS(s): BK46K 2008 - 2009 Highlander 2006 - 2009 RAV4 Engine(s): 2GR VDS(s): BK31V, BK32V, BK33V, BK34V, ZK31V, ZK32V, ZK33V, ZK34V, ZK35V 2007 - 2009 Sienna Introduction This service bulletin provides information regarding valve timing inspection and service guidelines for vehicles equipped with 2GR-FE engines. © 2008 Toyota Motor Sales, USA Page 1 of 5 T-SB-0291-08 September 11, 2008 Page 2 of 5 2GR-FE Valve Timing Procedure Introduction (Continued) Figure 1. 3 2 1 5 9 8 7 6 4 1 RH Bank Intake Camshaft Timing Gear 2 RH Bank Exhaust Camshaft Timing Gear 3 RH Bank No. 2 Timing Chain 4 Crankshaft 5 Idler Gear 6 Timing Chain 7 LH Bank No. 2 Timing Chain 8 LH Bank Exhaust Camshaft Timing Gear 9 LH Bank Intake Camshaft Timing Gear Warranty Information OP CODE DESCRIPTION TIME OFP T1 T2 N/A Not Applicable to Warranty © 2008 Toyota Motor Sales, USA T-SB-0291-08 September 11, 2008 Page 3 of 5 2GR-FE Valve Timing Procedure Inspection 1. Set the No. 1 cylinder to TDC/compression. A. Set the timing mark to 0 on the timing chain cover by rotating the crankshaft clockwise. B. Verify the timing marks on the camshaft timing gears are in general alignment with the timing marks of the camshaft bearing cap: TIMING MARK IDENTIFICATION CYLINDER BANK INTAKE GEAR MARK EXHAUST GEAR MARK RH Bank (Bank 1) Small Mark Single Line LH Bank (Bank 2) Large Mark Double Line HINT When the engine is correctly timed, the timing marks will NOT perfectly align. Figure 2. Figure 3. RH Bank Exhaust Camshaft Timing Gear 1 2 1 Bearing Cap Timing Mark 2 Gear Timing Mark Figure 4. RH Bank Intake Camshaft Timing Gear 2 1 1 Bearing Cap Timing Mark 2 Gear Timing Mark © 2008 Toyota Motor Sales, USA T-SB-0291-08 September 11, 2008 Page 4 of 5 2GR-FE Valve Timing Procedure Inspection (Continued) Figure 5. LH Bank Intake Camshaft Timing Gear 1 2 1 Bearing Cap Timing Mark 2 Gear Timing Mark Figure 6. LH Bank Exhaust Camshaft Timing Gear 1 2 1 Bearing Cap Timing Mark 2 Gear Timing Mark HINT If the timing marks appear vastly out of alignment, turn the crankshaft one revolution (360 ) clockwise and note the position of the timing marks. Component Removal Guidelines 1. If engine disassembly is required that involves removing the camshafts or timing gears, set the #1 cylinder to TDC compression, wipe away any oil, and mark the following items in relation to each other prior to disassembly: • Timing gears • Timing chain • Timing chain No. 2 NOTE This relationship MUST be maintained. The intake gear is timed in relation to the crankshaft via the timing chain; the exhaust gear is timed in relation to the intake gear via the No. 2 timing chain. © 2008 Toyota Motor Sales, USA T-SB-0291-08 September 11, 2008 Page 5 of 5 2GR-FE Valve Timing Procedure Component Removal Guidelines (Continued) 2. If NEW camshaft timing gears or the No. 2 timing chain are being installed, the two yellow links on the No. 2 timing chain can be used to ensure correct relationship between the intake timing gear and the exhaust timing gear. Figure 7. 1 1 Yellow Link A. Align the paint mark on the timing chain with the intake gear timing mark (to ensure the intake gear is correctly timed to the crankshaft). Figure 8. RH Bank and LH Bank 3 3 4 3 3 4 5 4 5 4 1 2 1 RH Bank 2 LH Bank 3 Yellow Link 4 Gear Timing Mark 5 Timing Chain Paint Mark B. Align the two yellow links on the No. 2 timing chain to the timing marks on

2006 Toyota... | Answered on May 05, 2015 | 1,501 views


Either your rear windows leaks or the boot seal is cracked, torn or not glued properly on the car body flange. Check these first, or try and sit in the boot with a strong torch and have someone to hose the rear part of the car. Usually you'll find the leak and fix it.

2006 Toyota... | Answered on Mar 03, 2015 | 1,087 views


could be battery in the remote. google fob repair kit for 2006 Toyota Avalon XLS and see what comes up. I have repaired GM fobs for under $10

2006 Toyota... | Answered on Feb 17, 2015 | 293 views


sounds like a fuel filter needs to be replaced

2006 Toyota... | Answered on Jan 25, 2015 | 89 views


Is it making odd sounds? Is it not running well? What's going on with it?

2006 Toyota... | Answered on Jan 25, 2015 | 28 views


There will be a relay possible faulty u can over ride it using a wire but I'd find the relay and change it as I'm not sure the location

2006 Toyota... | Answered on Jan 25, 2015 | 66 views


did you check fuses

2006 Toyota... | Answered on Sep 06, 2017 | 430 views


The power outlets need a ground to work. Maybe the ground wire isn't connected to the power outlet.

2006 Toyota... | Answered on Oct 15, 2014 | 140 views


is on the engine compartment fuse box

2006 Toyota... | Answered on Sep 12, 2014 | 149 views


Should be screws on the hinge

2006 Toyota... | Answered on Aug 26, 2014 | 306 views


undo the bolt on the front of alternator ,pulley will then lift away

2006 Toyota... | Answered on Jul 19, 2014 | 138 views


the way to remove pulleys from most alternators would be to use a gear/pully puller these gear pullers use a ratchet to push the pulley off of the shaft

2006 Toyota... | Answered on Jul 19, 2014 | 117 views


yes this has been a problem since reverse was invented... it's called trial and error.

2006 Toyota... | Answered on Dec 30, 2013 | 114 views


The thermostat is located at the rear of the engine, just follow the large radiator hose to where it connects to the engine you will see the thermostat housing.

2006 Toyota... | Answered on Feb 15, 2013 | 132 views


Sounds like you need a wheel balance and alignment.

2006 Toyota... | Answered on Sep 18, 2012 | 504 views


the antenna is on the rear glass behind the right side molding at the rear glass is the connections for the rear defrost and ant check the wire connections

2006 Toyota... | Answered on Sep 18, 2012 | 300 views

Not finding what you are looking for?
2006 Toyota Avalon XLS Logo

71 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...