20 Most Recent 2006 Toyota Avalon Limited - Page 6 Questions & Answers

It sounds like you have a failing wheel bearing.

Hi,food for thought,if your hazzard lights work then the problem maybe the indicater stork,hope this was some help.

hello sir i am a mechanic. take 2 mechanic like me. DING

On this website you find fuse box diagram and description for Toyota Avalon Toyota Avalon First Generation XX10 1996 fuse box diagram Auto Genius

Toyota has had problems with their throttle systems, I have never seen an accidental, unwanted acceleration, but I have seen pedal and throttle position sensor codes several times with theses systems. You need to scan the car for codes, as there are several hundred. The VCS and ETS are all part of the same system, that being the power train control. Take it to a Auto zone for a quick scan or you can buy cheap scanner online that will give you just the codes to Google the problem. Since you have an ETS light which is a malfunction with the electronic throttle control, then you will get a check engine and a VSC light as well as they are all dependent on a properly working electronic throttle system. Good Luck :) Amazon com Oxgord CAN OBD II Scanner Tool for Check Engine Light... If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_70466cb634a57543

hook speaker wires to the amplifier output, can't use from the radio wires because they used a not smart design using one wire output from radio to amplifier, the amplifier output is connected to your soeakers, a simple check, use 1.5 battery to speaker and check the speaket, should move, or hook to some cd player output, easier that way

Hey Please visit the site .They give you great deal or discount

Does the motor make a noise like its trying to pump when you press the water button? Best way to check is when the car is off and you turn the key to accessories, then try the water. If you hear a humming noise, your fuse and motor are working and you have a blocked spray unit. Just use a pin to unblock it. If you dont hear a humming noise, locate the fuse and see if it is faulty. If the fuse is fine, your motor is bad so replace it. Hope this helps

ask from the Toyota for English version or do translation by some one

At a guess I would start with the immobiliser. It may need to be re-set due to the battery being disconnected.

Check battery condition/terminals. If ok then > starter and solenoid.

I had that , and it was the transmission low on oil. Hope this helps.

Remove the combination switch on the steering column, see if the lights go out when you disconnect the wiring plug.

from your description the do it your self fix is another motor from the wreckers. If it is a big end there will be crank shaft journal damage and that means major rebuild and lots of dollars A replacement engine will be cheaper and less costly in the long run.

Chances are you have warped brake rotors. Typically, the problem will be in the front brakes. Change the rotors, and brake pads while you are at it, and you will be good to go.

a bad injector can cause a miss, you can listen to each injector with a stethoscope. It should make a rapid clicking sound. If it makes a deep thumping sound it is likely bad. also an intake leak can cause a miss at idle. also an EGR valve partially open can cause miss at idle. I always check cylinder compression when replacing plugs or coils for a miss. You need quality tech to check for above items.