2010 Renault Clio 1.2 - Answered Questions & Fixed issues

would need to see it sorry,could be anything or everything as it is a renault with encrypted software ,check the obvious first like spark plug gaps ,25th then if still the same maybe the coil pack

Have you tested the battery??

? what

I could be wrong, but I believe that model of clio is fitted with electric power steering. The electric motor is fitted inside the car on the steering column. If there is a problem with the steering it will need to be checked by a renault dealer. The power steering motor thermal cut out is a common issue.

check brake pads, they might be worn out.

Check the length of the bolts (118.5mm max) stage 1- 20 Nm, stage 2- 20Nm, stage 3- 100deg +-6deg, stage 4- 100deg +-6deg and for the cam sprocket 45Nm, camshaft stage 1- 8Nm, stage 2- 12Nm, inlet manifold to motorhead: upper part 9Nm lower part 21Nm, exhaust manifold to motorhead 18Nm

I'll need a bit more information please. Exactly which light is this? Brake light, Tail light, Fog light, Reverse light? When exactly do they stop working? Do they fail as you turn them on or while you are driving? The easiest starting point here is to look at the light fitting itself and the block connector fitting to it. There could be a dirty or damaged wire causing the lights to 'short' out and stop working. As they sometimes work it is probably not a fuse problem. If you know how to use a multimeter you can test for power from the wires. Please comment below with more information and i'll try to help you more.

fixya doesnt sell products

If this is on a UK vehicle the first place to look is the lower right hand corner of the windscreen, looking from the outside. There should be a copy of it visible just under the glass. Another place to look is down in the step area on the driver's side, (Right side of the vehicle as you drive). Open the door on the right side of the vehicle. On the lower step 'kick' panel, (the area usually hidden by the closed door), there should be a small rectangular plastic cover plate. It should hook out using a small screwdriver to reveal the VIN.

ie, head bolt torque.. chances are they are in the 50-60 ft pound range.

Limp mode. Have diagnostic test done for fault codes

If the clutch is slipping you may need to replace clutch friction plate

Purchase a new belt from the local Renault and than fit it if you cannot fit it yourself get a local mechanic to do the job

Could be cam belt

Built in to the upc computer. Right side of the battery

Idle air valve jammed or defective?

Do you have steering wheel controls?

Easiest way to fix this is to have the error code/s read using an OBDII reader.. Dealers can do it, but charge a lot.. see if you can borrow one, or use a local garage to read them cheaply.. Or buy a code reader, they are not too expensive, and cheaper than having the dealer read the codes.. Once you know what the codes are, you will know what is wrong, and also an idea of cost to repair.

Do you always go to the same pump? Some are more sensitive to others. But they are designed to prevent spillage, so will turn off when they sense back pressure. Maybe you could try filling slower. If that doesn't help, it is possible that there is an obstruction or damage to the filler pipe of your car - get your service garage to look at it.

I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years