20 Most Recent
2006 Peugeot 407 1.6 - Page 3 Questions & Answers
Rear brake caliper will not compress
if the tool you are using does not apply pressure and spin the clip at the same time then it is an inferior tool and you will have to think of a way to apply more pressure while spinning the clip. put a drop of oil between the protective rubber boot and the piston so as to not rip it. sometimes the threads are seized and the calipers have to be disassembled and cleaned, but I doubt that this is your problem because it very rarely happens to both sides at the same time. the biggest problem is being able to apply enough pressure to the clip while it is still on the car, and I sometimes have to remove them and put them on a bench vice to retract them properly.
Peugeot 407 06 sw front driver's door open (fault)
This will save you loads of money and stress ok. Been using this simple solution for about 18 months and still working. On your lock bar (not door lock) but the u shaped bar that the lock latches onto! on pillow of car. Don't laugh ok ha ha ! just rap electrical tape around bar a few times to make it thicker. You might have to experiment by adding or taking layer of tape off. your door should lock ok and door sensor fault will not appear. "YES" its as simple as that ! Tape will wear but its a 2 minute job to redo and the estimated cost will be 50p lol. three garages told me I need new lock fitted and then the thinking light bulb shon so brite! Hope this works matey, good luck. Gaz from Newcastle on Tyne.
Not finding what you are looking for?