2005 Mercedes-Benz Sprinter 311CDI - Answered Questions & Fixed issues

All you need to do is disconnect the battery negative side for a minute. That will reset the light but only for a short time if you did not correct the problem that is causing it. You can also take this to an Oreilly auto parts and they will hook up the diagnostics tool for free and turn it off for you.

Spray them with a good penetrant, (Kroil for example) let it sit for a few hours, spray the penetrant again, then tap them lightly with a small ball-peen hammer. Then heat up the block around the plug with a very low temperature torch (propane), then use the specialized tool to loosen up the plug, go back and forth, do not loosen in one direction, spray penetrant again while loosening. If you need further help, reach me via phone at https://www.6ya.com/expert/daniel_4061c3d97c12c4c7

You need the wiring harness and sensors off the 2 seater.

It cant start until you replace heater plugs an reset it

sounds like an electrical problem check all fuses and ac clutch relay

Most cars and trucks can be re-set by disconnecting the negative batery cable for about 10 minutes...this should auto re-set to factory specs...if the light comes back on, you have wired into the wrong system. Hope this helps.

notify dealer or authorized repair shop that can hook up for computer changes

You might be able to buy a code reseter,and reader.

At this website www.reliable-store.com I found so much of information on how to repair vehicles and technical issues in detail.. Also complete, much better language, and they also have live assistance feature

there is a pressure relief valve in the hydraulic pump if you have no or very little pressure being generated , it may be that that valve is jammed in the open position or the spring controlling it has broken in any event the basic problem is that the hydraulic pump is not producing a volume sufficient to build up pressure check the installation of the filter as it may be restricting oil flow to the pump in installed incorrectly

I have a 1994 c ckass w202 mine did this it blew hot air all the time realy anoying in the summer lol any way it was the controler that wss at fault the bit on your dash that regulates the temperature if not yhere is a mixture valve under the bonnet itvregulates how much water goes into the heater matrix

As the vehicle has just had a full service your van shouldn't be suffering those problems and you should return to the repairer and complain bitterly, do a war dance or whatever it takes for them to finish the job and deliver what you paid for. If your Sprinter is fuel injected and catalysed there will be nothing to adjust but you need to know the CO2 content rises as the engine runs more efficiently while it is the CO level that should fall. There are many reasons for poor fuel economy other than high exhaust emissions but after a proper full service the vehicle should already be running as efficiently as possible.

have 2013 Mercedes rv message 0208 and yellow lights not blinking of ABS, tire, and car

Check engine light on? Any fault codes? If no to these questions then you just have an underpowered truck and you will have to live with it or trade up.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. 2006 Mercedes

I have the same fault in my 313CDI.
By pushing the alarm button the horn works.
Sometimes the horn worked intermittently so I suspect the wiring/ contacts on the steering wheel?

the fuel gauge works on an electric pulse. if it is unplugged it will go to empty if it is plugged i it will go up as fare as the tank is full. if it goes higher then the known fuel lvl. you have a bad gauge if it goes up and down when you know it is full you have a bad connection

where is starter relay of sprinter 316

You have to bleed the hydraulic clutch. Easiest way is to reverse bleed...open bleed nipple on slave cylider and pump the fluid into the cylider and the trapped air will vent through the reservoir ( i use an old winscreen washer pump with hose on it)

Do you really want to trust some total stranger to give you this critical information instead of buying a cheap shop manual? Your choice I suppose.