20 Most Recent 2007 Kia Sorento 2.5 Questions & Answers

Black smoke means you have too much diesel in the mix that is being ignited. This can be because either too little air is getting in or too much fuel is going in. First step (easy and cheap) is replace the air filter. If there's still smoke check the erg valve is clean and moves easy. If it's still there after that then check the common rail injectors for leakage.

there is a pet cock at the bottom of the radiator. it will either be in one of the bottom corners or directly in the middle. Or you can just pull the lower rad hose off and put back on. please make sure the engine is cold when doing this. the best way of refilling it would be to go to an auto parts store and buy an antifreeze "burp" funnel. Use this funnel by attaching it to were the rad cap is fill it with coolant then start the car let it run till it gets to operating temp and watch the funnel till no more bubbles are present. you can speed this up by turning your heater on while doing this procedure.

Is a belt and is recommended at 65k or70k

In the link and a video as well. NOTE: they are POUND INCH not Foot Pounds.

Torque Pattern for Valve Cover? - Kia Forum

kia-forums.com https://www.kia-forums.com > threads > torque-patter... Sep 17, 2013 - show the locations of the bolts on the "Cylinder Head Cover" --aka valve cover-- and they provide the torque at 35-52 lb-in (4-6Nm), but they ... Valve Cover Gasket help Apr 28, 2012 Torque specs and sequence for intake bolts Jul 10, 2022 Need Bolt Pattern for Valve Cover, please help? May 15, 2018 torque specs? Mar 20, 2017 More results from www.kia-forums.com ..

order parts remove door panel and replace parts

https://eautorepair.net/Marketing/Default.asp pay and read,

It's not complicated ! when you turn on the overhead light with one or either switch you see 2 lights. BUT there's another bulb between them that is the one that comes on with a door opening. Remove cover and replace the burned out middle bulb.

Question edited for clarity and typo. some help in the link. https://www.google.com/search?q=2016+Kia+Sorento.+4WD+actuator+replacement ..

Yes I have one.message me: [email protected]

It can only be a few things Gail. Fuse is the first thing to check. Then check the switch for power and continuity. You have changed the resistor, so we assume the new resistor is good. The only thing left is the blower motor itself. Remove it and add 12 volts to it.

Set the blower control on high with max a/c then try to tap on the blower motor and if it run or starts and stops replace the motor.

should be on the shifter ----check with your owners manual

https://www.obd-codes.com/p0016 https://www.obd-codes.com/p0018 these two links should help fix your problem

limited info generic answer ---wont complete the test ??? need more clarification --is the obdll not communicating --or is it failing do to not ready conditions --as to the way you wording your question would suspect some kind of ecu failure or harness

There is a short in the wires causing the fuse to blow. Check the wires at bend points and how they run to the fuse box. Something is probably pinching or rubbing the wire cause a short.