20 Most Recent 2005 Hyundai Tucson GL Questions & Answers

Make sure the brake lights actually work. Also there is usually a small removable piece on the shifter (a plug filling a hole) after removing it you can stick something in there to release the shift interlock to be able to override it and shift it. Or the shifter is broken, or gummed up with something that was spilled on it.

can be faulty spark plug can be faulty HT lead can be faulty coil (if individual) can be faulty distributor cap ( if it has one) can be faulty injector can be faulty injector nozzle (blocked) can be mechanical fault---loose valve seat insert , burnt valve --hydraulic follower

if you follow the spark plug wires they should lead you to the spark plug. when you remove the spark plug wire you may want to give it a little twist just to break it loose from the spark plug than pull the wire off. than you just use the right size spark plug socket to take the old plug out and to put the new plugs in once the new spark plug are in just push the spark plug wire back on. make sure you gap the spark plugs right if you don't you could end up with a misfire in that cylinder also be careful not to crack the new plugs if you do you will need to get another new spark plug.

did you tune it up at all , do u have a ck eng light on , do u have a vacuum leak this would cause you symtons

remove rear windshield wiper connector then plug a voltmeter at these connectors as you activate the rear wiper..any voltage?yes! motor is gone,no voltage fuse is gone!

You can turn your dimmer up, and make sure you are turning on headlights. Newer cars with new guages makes it easy to forget. You can drive on driving lights and still see dash.

There is no fuse for the interior lights. It is likely to be the bulb or the door switch. The second Page link shows locations.

2005 Hyundai Tucson fuse box diagram

StartMyCar https://www.startmycar.com > Tucson > Fuse box 2005 Hyundai Tucson fuse box diagram. The 2005 Hyundai Tucson has 2 different fuse boxes: Engine Compartment diagram. Inner Panel diagram.

Hyundai Tucson (JM; 2004-2009) fuses and relays

Fuse Box Diagrams https://fuse-box.info > hyundai > hyundai-tucson-jm-2... Here you will find fuse box diagrams of Hyundai Tucson 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside ... You've visited this page 2 times. Last visit: 2023-08-01

Hyundai Tucson 1 (ix35) - fuse and relay

FuseAndRelay.com https://fuseandrelay.com > hyundai > tucson-1 It is located in the left end of the dashboard, behind the protective cover. ... The fuses designated as C / LIGHTER or P / OUTLET are responsible for the ... You visited this page on 2023-08-01. ..

The mechanism of a reclining driver's seat in a car can be complex, and it may require specialized tools and knowledge to diagnose and fix the problem. Depending on the cause of the issue, it may be possible for you to fix it yourself if you have the necessary skills and tools, but if you are not experienced with automotive repairs, it may be best to take the vehicle to a professional mechanic. Before attempting any repairs, you should consult the owner's manual for your vehicle to understand the seat mechanism and any safety precautions you should take. If the problem is related to a broken part or a loose connection, you may be able to fix it by yourself with some basic tools. However, if the issue is more complex or requires a replacement part, it may be best to take your vehicle to a professional mechanic or an authorized Hyundai dealership for repair. They will have the expertise and experience to diagnose the problem and repair the seat mechanism correctly and safely.

The problem is with the fuel system or possibly the fuel pump. Try checking the fuel pressure and ensuring enough fuel gets to the injectors. If the fuel pressure is adequate, but the injectors are not pulsing, you may need to replace them or have them professionally cleaned. If the fuel pressure is too low, then check the fuel pump and its related components

https://www.mahle-aftermarket.com/media/local-media-north-america/pdfs-&-thumbnails/torque3.pdf

https://www.youtube.com/watch?v=u1IA6hgM40E Seems like they have a lot of problems. This video may help you.

Tucson has this notorious problem. The door locks operate using a steel cable, just like the clutch cable of most of the motorcycles. This cable stretches out with time and eventually, the throw of the lock (the range of motion) would not be enough to pull the cable sufficiently and unlock the cars. On youtube, you'll find some fixes which basically suggest to cut the stopper in the lock mechanism to increase the throw length of the lock latch.

clutch on compressor.

When it is serviced at your Hyundai Dealership, mention the noise and as it is under warranty, they will sort it out for you.

I wouldn't have thought it would run without a MAP sensor! Here are some videos, but if he cut the wires and connectors, you aren't going to have much luck. Videos on replacing it here. https://www.google.com/search?q=2007+HYUNDAI+TUCSON+replace+MAP+sensor ..

While there are a variety of reasons your Hyundai Tucson is overheating, the most common 3 are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat.