20 Most Recent 2011 Hyundai Elantra Limited Questions & Answers


I ran into the same issue... everything was working correctly from the display screen (AM,FM,XM,iPod,Bluetooth) picking up stations, and all controls were working, but no sound at all. I called the dealer and found out there is a reset button that reboots the entire nav/audio system. It is a pin-hole located just to the left of the CD slot on the console. You will need a paper-clip or somthing that size to push it. Hold it in for a few seconds while the system is on and it will shut down and reset. I have to warn you that it does erase almost all of your presets, but did seem to keep my Bluetooth pairings and my nav address book. Good luck!

2011 Hyundai... | Answered on Jun 27, 2019


To solve out the issue of resetting the audio of you 2013 Hyundai car, here I have attached the video for you which will explains how to reset the stereo head unit of your Hyundai Elantra, have a look

2011 Hyundai... | Answered on Dec 12, 2017


take the car to a suspension specialist shop and have the rear wheels aligned first
have the suspension checked for worn mounts or bad springs
it is very important that the rear end is aligned before the front end
suspect that the suspension rubbers need replacing as it is over 6 years old
the tyre rotation is a myth perpetrated on drivers to sell tyres
when the tyre construction was cross-ply and not radials yes rotation then on cross-ply tyres could get the wear to even out but with radials once the wear is started then the tyre continually wears in that pattern regardless of which wheel it is on
even if you take that tyre of the car and put it on a trailer , it will still continue to wear in that pattern
tyres are no longer rotated but simply put front to back on the same side other wise the belts flex in a new direction in the tread and fail earlier that expected
besides that fact that tyre rotation will not allow you to monitor for suspension problems or wheel alignment problems and cost you 4 tyres at a time instead of two

2011 Hyundai... | Answered on Aug 20, 2017


You are better off contacting the dealership to have these items looked at. Depending on warranty, it may be a covered item. And if this issue results in a problem with the display and not the camera, many of today's newer cars have these systems VIN programmed, which will put you in the dealership anyway

2011 Hyundai... | Answered on Dec 02, 2014


connections to the radio defective or the radio itself!

2011 Hyundai... | Answered on Apr 02, 2014


Take to a dealer---- under warrantee

2011 Hyundai... | Answered on Aug 06, 2013


I just got the same message today...and rarely use the cd player. Was wroking, went to change cd's, then it would not load and gave error 43...anyone?????

Hyundai Elantra... | Answered on Sep 26, 2019


Im not sure if your fuse box looks like the screenshot however if it does I would at your own risk turn this switch off and back on as suggested in the other photo.
Again I am not a mechanic, I do however try to give the best advice I can.
Hope this helps.
9_12_2019_3_41_38_am.png9_12_2019_3_41_40_am.png

Hyundai Elantra... | Answered on Sep 12, 2019


Just for fun try unhooking your negative battery cable for a couple minutes to do a reset or reboot .

Hyundai Elantra... | Answered on Aug 21, 2019


Check the fuse and relay related to the AC. Your fan should come on when the AC is turned on. Right now the fan is working only off the engine temp., not the AC.

Hyundai Elantra... | Answered on Jun 12, 2019


Hose is held to suspension strut with c-clip, loosen and retighten union joint while still in clip for ease of undoing. then remove clip holding hose with pliers
Top up reservoir and to avoid fluid loss, Clamp existing rubber hose off above Wheel cylinders callipers. Spread brake pads slightly to clear disc rotor edge then undo callipers from hub - suspend from strut with cord or wire and unscrew old pipe. Immediately replace existing with new hose to callipers. With master cylinder reservoir sealed airtight undo union nut at top of existing rubber hose where clipped to strut. Replace existing lower hose fitting with new hose.Tighten union. replace c clip and bleed brakes at nipple on callipers until all air out of lines.
Job done road test for hard pedal repeat bleeding as necessary.

Hyundai Elantra... | Answered on Jun 03, 2019

Not finding what you are looking for?
2011 Hyundai Elantra Limited Logo

22 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Elantra Hyundai

  • Elantra Hyundai

Most Popular Question

no sound from speakers

  • Cars & Trucks
Loading...