2008 Honda Jazz 1.4i - Page 3 - Answered Questions & Fixed issues
Where is the purge valve located on a Honda Accord 2001 v6 3.0l
Frequently the purge valve is located on near the engine or on the engine. You can locate it by the hoses to and from it. It will be fed by hose coming from the tank and from the valve a hose goes to the intake manifold. It also has a connector to it.
11/27/2023 7:26:51 AM •
Honda Cars &...
•
Answered
on Nov 27, 2023
•
780 views
Another Question 95 Honda Passport 3.2 v6
you need the piston at TDC and cam marks lined up on markers. If you don't the valve and ignition timing is off. I sent you a link regarding this. It is your car, your money.
10/29/2023 12:27:05 AM •
Honda Cars &...
•
Answered
on Oct 29, 2023
•
22 views
95 Honda passport 3.6 V6 what if my cam sprket marks don't line up when the craks shaft mark does after turning it alot of times.
One possibility is that the timing chain has jumped a tooth or more. Another possibility is that the camshaft has rotated out of position.
I found a forum post on ThumperTalk where a user had a similar issue with their Yamaha dirt bike. The post suggests that you should first line up the flywheel TDC mark, then line up the camshaft/sprocket TDC mark, and then put the chain on. Once you have done this, rotate the engine flywheel counter-clockwise four times until the mark comes back around on compression stroke. Line up the crank on TDC making sure that there is no slack on the front side of the timing chain (exhaust side), which is away from the chain tensioner. If it doesn't line up, repeat these steps because you may have jumped a tooth somewhere when installing it.
10/28/2023 4:36:08 PM •
Honda Cars &...
•
Answered
on Oct 28, 2023
•
35 views
No one can figure this out not even Honda.
Suggest you focus on recreating the problem. If it's an automatic try power braking in reverse. Hold the brake on with left foot so the car doesn't move and slowly press on the accelerator. This will torque engine and drivetrain to maximum and may reproduce the problem at will.
10/14/2023 5:06:05 PM •
Honda Cars &...
•
Answered
on Oct 14, 2023
•
44 views
Where is the fuel cut off switch for honda crv
There isn't one. If you have no fuel pressure, you need to make sure there is 12v getting to the pump. If there is and there is a good ground, but the pump isn't running you need a new pump. If there isn't you need to go further up the circuit to figure out why not. Either the signal isn't getting to the fuel pump relay or there is a signal and there is an issue with the relay.
10/13/2023 5:00:58 PM •
Honda Cars &...
•
Answered
on Oct 13, 2023
•
44 views
Not finding what you are looking for?