20 Most Recent 2006 Honda Accord 2.4 - Page 4 Questions & Answers

Have you tried looking at the instruction manual that comes with your phone as I am sure this will tell you the correct way to charge it.

Check for spark at one of the plugs . If you have spark spray a shot of carburetor cleaner into the throttle body and see if she fires up .

I had this problem half year ago, and traced to bad spark plugs. Seem like two of the plugs were the correct type for my 95 Accord LX. They did not fire correctly and eventually both ignited together causing exempt interference with the high voltage coil. I cannot explain more than this, but pull the plugs and see which one or two may be bad and also check the high voltage coil and spark wires. Good luck.

Take it to the dealer . Battery Disconnect or Replacement Problems

I had a drained battery every three days and it turned out to be the antenna motor, because the noise come from the back seat but driver side.. Ended up disconnecting the power antenna. Your Accord seems to have a different issue than mine, but I thought I would throw it out for consideration.

Have a 95 Accord 4 cyl. I cleaned the battery terminals and changed the high voltage coil as well as two of the four plugs.

Go to www.reliable-store.com and get info on whether to repair or not, service it or not, and how to repair etc

If you're comfy with manuals then i know few websites that can help you with it. Bcause I've got it from various websites so I know how each site deals. try www.reliable-store com . Very helpful

A couple of DIY things come to mind.. 1, make sure you have a good ground connection from the battery to car ie not corroded, clean good connection both ends. 2. The ICU (integrated control unit) is failing or has some corrosion on the connectors. It's on the back of the fuse box. It controls •Intermittent Wiper Control Circuit •Side Marker Flasher Circuit •Seat Belt/Key-in Beeper Circuit •Lights-on Reminder Circuit •Low Oil Pressure Flasher Circuit •Rear Window Defogger Timer Circuit Best to you

I don't know yor model but on my Toyota in order to start the car I had to press breaks. Once car didn't start, I found that there is switch connected to break pedal and rubber tip broke of the switch and it didn't sense that breaks are depressed and prevented me from starting the car. There is possibility that similar safety is used in your car.

The Crankshaft Position Sensor for the 2.3L 4-Cyl. engine is located behind the crankshaft pulley on the oil pump assembly. DTC P0335 How To Change Honda Accord Crankshaft Position Sensor

Each car is slightly different, but behind the head light, under the bonnet, there will most likely be toggles that you need to push in that will release the lock, and you can then pull it out. It will take a bit of strength and wiggling, but once you do one, they other will be pretty straight forward.