20 Most Recent 2010 Ford Flex Limited Questions & Answers

The most common cause of this is that you have a stuck air temperature control blend door, this can be a motor actuator issue or a jammed door or both (common). To replace both parts you will need to completely remove the dash from the car to access the blend door.

If your sure you're looking at the right motor, Then the door is broke. Dash and plenum have to come out to fix it. Not a cheap fix.

In the fuse box in passenger compartment

Hello. The PCM on your Ford Flesx is in the engine compartment, on the driver side by the battery. Good luck and keep me informed; if you want to.

Make absolutely sure there isn't anything, ANYTHING, in the seat or on the floor under the seat, or anywhere that will trigger the safety sensor. I had an empty bag trigger the sensor that disallows the tumbling action.

Disconnect the MAF sensor in the air cleaner duct. Might start and you can get it to Ford for a THOROUGH diagnosis. don-ohio

Start by checking your engine coolant. If the level is good, let it warm up and feel the heater hoses. They might be hard to find. They look like radiator hoses, just narrower. If both hoses are hot, you may have a problem with the blend door. It controls the temperature of the air coming out of the vents. Good luck.

Not security, Probably a bad ground or positive conecction.

by connecting the power wire to a permanent live

Suspect a air lock but i couldnt be sure and i would need a look myself to be sure ? sorry for a non positive answer

if it has factory alarm check that first