20 Most Recent
2005 Fiat Punto Questions & Answers
Water leaking where hoses join engine block
The water hose connects to a plastic section that slots into the inlet manifold. This then relies on a rectangular shaped rubber gasket to seal against the engine block but can easily leak so a good idea is to add some silicone gasket sealant before tightening the inlet manifold nuts and the 2 bolts that hold the water section of the manifold
Why does my car vibrates when pulling of in 1st gear?
this has happened to me before, the gear boxs are very soft in these cars, i had to get my gear selectors done in the car, and had my clutch checked as they are very soft clutchs and can easly wear, have your clutch checked as the garage had informed me that it can make the car shutter,vibrate and stick when its going and after a full service my car was back to normal.
Engine management light on trouble code P0335
P0335 - Crankshaft Position Sensor 'A' Circuit MalfunctionPossible causes- Faulty crankshaft position sensor (most common)- Crankshaft position sensor harness is open or shorted- Crankshaft position sensor circuit poor electrical connection- Signal plate may be damage- Starter motor may be faulty- Starting system circuit- Dead or weak battery causing slow engine crank over.
What does the yellow triangle light? I have piat punto car
Its the "Check Engine Light" also known as the CEL. If it is just "on" and not flashing take it to your mechanic or dealer and get them to scan the "On Board Diagnostic" (OBD) for a fault. Often CEL faults are minor and clear themselves. Is the car doing anything else?
If the light is flashing it indicates a major problem then you mustn't drive the car. Ring the mechanic and ask them what to do. It may require towing the car.
You can also contact the
http://fiatforum.com and ask the question there. Most car forums have plenty of members with deep knowledge of your vehicle and any issues it might have.
Yet another option is to purchase an "ELM327" Bluetooth OBD adapter on eBay for just a few dollars.. You then have a tool where you can scan the "CanBus" (connected to the OBD) and it will read the fault log. I recommend and use "Torque" - an android app for ~$4US to connect. First time you use it, it will save you money. Once you have the fault log, a few minutes googling the codes it shows will tell you what is causing the CEL.
Not finding what you are looking for?