1998 Citroen Xsara 1.6 - Answered Questions & Fixed issues
How to rear brakes
hi
number of things.
could be brake pad or seriously weakend discs
could be calpier on its way.
brake fluid may have too much water contamination
5/31/2016 3:22:53 PM •
1998 Citroen...
•
Answered
on May 31, 2016
•
31 views
Citreon xsara 1999 1.8 16 valve cylinder head torque settings
If yours is an Xu series engine, you need to use a torque wrench and an angle dial wrench. Tightening is in 3 stages.
- Stage 1: Tighten up to 60Nm (44 lb/ft) then fully loosen
- Stage 2: Tighten up to 20Nm (15lb/ft) change to angle dial wrench
- Stage 3: Angle tighten to 300 deg.
To avoid confusion, do stage 3 in 3 steps, tighten 100 deg each round and repeating the cycle until 3 rounds.
6/13/2014 10:26:16 AM •
1998 Citroen...
•
Answered
on Jun 13, 2014
•
578 views
Valve timing order citron xsara199 1.8 16valve engine
I don't know this car, but the #1 cylinder is always at the front of the engine. The front is where the crankshaft pulley turns the serpentine belt or all of the belts that are utilized, and the rear of an engine is where the transaxle mates to it. So the cylinder numbering order is 1-2-3-4.
The firing order on all 4 cylinder engines is 1-3-4-2.
6/2/2014 5:02:32 AM •
1998 Citroen...
•
Answered
on Jun 02, 2014
•
160 views
Ecu problem
Dont think so ,i think more like a valve burnt out ,do a compression check first before playing with it ,remove all plugs and then check the compression
3/12/2013 6:13:31 PM •
1998 Citroen...
•
Answered
on Mar 12, 2013
•
81 views
Citreon C2 1.4 Furio 2004. When you pull up at traffic lights, the engine idles, goes into second gear,but then no revs to pull away.So push car over to Kerbside, wait ten minutes it drives as normal?
You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thi ng is covered
within seconds u can get the access and it's totally illustrative complete
How to remove xsara picasso front seats
Your seat is usually bolted to the floor of the vehicle. If you remove the bolts and unplug any electrical connectors you should be able to remove the seat. You will need to fabricate brackets that attach to the vehicle as the original seats did and then the brackets will need to attach to your new seat.
12/20/2017 7:13:37 PM •
Citroen Xsara...
•
Answered
on Dec 20, 2017
•
2,027 views
Not finding what you are looking for?