20 Most Recent 1998 Chevrolet Venture Questions & Answers

Hi orvil brad hear I would check the ing. fuses you have at least one and maby two in the inside cab fuse block, and also one or two in the engine bay fuse panel, there is also a relay located in the eng. bay panel, also you may check the ing. wire that goes to the coil system, This wire will have no 12volts until the ing. switch is turned on then it will show 12volts. It has a habit of coming loose at the coil sometimes. Good luck

Turning over is engine cranking, not running. I'm not sure I understood your post? Use a gage and check proper fuel pressure, 3.4L engine, 41--47 psi. Any applicable trouble codes? To check codes yourself, at the least you need an obd2 code reader. I'd want to check if system is running rich or lean?

Don't have a lot of experience with this model , but , sounds like rev limiter is engaging because computer believes vehicle not moving maybe ? Is speedo working if electric ? if speedo geared then is speed sensor bad , I have seen that before . Hugh

Check the for a leak on the vacuum tubes.

check to make sure the rad coolant fan is operating, then if its okay get a head gasket test done as it may have a problem.

Primero checa la precion de la bomba de gasoline y checa si hay chispa en las bujias y si todo esta normal cambia el sensor de pocicion delaselerador y el map sensor

Most mechanics get that from dealer mechanic on his computer. I have gotten them several times over the years and it costs nothing.

need a little more information but it sounds like either mass airflow sensor or passlock securtiy issue

cambia tu filtro de aire y tu filtro de gasoline checa tus bujias

check for bad contact,low switch,wiring and most of all check the bulb

if your car is losing coolant or water it could be head problems or head gasket blown,if not losing water or coolant,,then my be distributier cap or leads ???mick