2006 Chevrolet Equinox LT - Answered Questions & Fixed issues

Fill the coolant to hot full. start it and get it to operating temperature, watch the tank because when the T stat opens the coolant tank will drop. Fill it hot full again, maybe just an inch or so over full. put the cap on. What I do is find a parking lot and drive around in circles( as fast as you can, 15 MPH is what I try to hit), left , then right. Doing this purges the air out of the heater core. It has worked on every car I have done. Even the impossible Ford taurus's

Que automobile marca y modelo tiene ud.

What computer port ?

The blend door will close off heat when it is facing heater core

Disconnect battery for a few minutes then reconnect. If the system didn't reset you may need to leave the battery disconnected longer even overnight.

the seat would need removing and the covering removing then replace the heating element , contact Chevvy for the cost of a new heating element ( if they are available ?) , or try a breakers for a used seat

a bad resistor = only high speed tired ,almost dead, blower fan = your problem

The light means the system is powered so the fuse is probably OK. I am not sure about this particular car but there is usually some measure of self test involved as well so it makes me think there may be a mechanical problem. Many systems use a vacuum device to actually adjust the throttle so a loss of vacuum such as a cracked line or a hole in the actuator could be the problem. On my Dodge truck the actuator lives beneath the battery so they frequently corrode a hole and no longer work. One last possibility is the linkage from the actuator to the throttle could be broken or jammed. Good luck!

Make sure the rubber gaskets are in place and not cracked.Could also be a covered drain hole in bottom of housing if there is supposed to be one.

Condensation in a headlight assembly usually means a crack or split in the assembly somewhere.Remove the assembly and use a hair dryer to dry it out. Go along to an auto supply store and get some "seam seal" (not silicone) and a silicone based lubricant.Spread the seam seal around the join in the headlight assembly and let it dry up.This is usually overnight.Take the silicone lubricant and apply it to the rubber gasket around each light bulb.DO NOT get the lubricant on the bulbs. Replace the bulbs in the assembly.This should solve your problem. Good luck

tune up

Bad sway bar kink.

try ebay

have someone check the power steering pump, if it's electric motor behing steering wheel then It can either be the assit motor or majorly the sensor, sensors anoy many people these days.. try it.

buy the manuel 25 - 30 dollars and look up electrical system

Three bolts are 70 lbs,could be 120+/-.

burn oil check market for release piston rings.

check brake rotors my need to replace or cut could be warped

You may have a bad fan and a bad fan relay or a bad coolant sensor. If the fan shuts after a certain period of time the coolant sensor is working. If the fan is extremely loud and grinding, replace the fan.

Double check that all fuses are still good and in the right locations. Sometimes they will pop when you install them right after you saw that they were still good. Let me know what you find.