20 Most Recent
2014 Dodge Avenger Questions & Answers
Looses power when driving
Probably your spark plugs or your coils. Have your mechanic check it for you. It doesn't take long for him to check.
Where is fuel filter located?
If not in the engine compartment, look under the car, follow the fuel lines from the gas tank. They will pass into an area protected by a removable metal cover. The filter is under the cover, you'll see a fuel hose going in one end and out the other. The remainder of the hoses that bypass the filter are part of the emissions system to soak up fuel vapors from the gas tank. Good luck.
2014 avenger. How do I remove the console between front seats?
Lift out any inserts or mats etc that are inside the console floor. Sometimes there are screws hidden there. Look around the sides and back of the console as well. There are usually a couple of screws on the sides and a few at the rear. You may also have to undo the gear shift knob if its a floor shifter. Move the seats all the way forward or backward to expose any screws or covers that hide screws for the console. If you have to force anything, it will mean that there are still screws or bolts, you have to have a close look.
How remove head rest
For Hard back seat, you have to pop the hard back seatby unclipping the Top 2
clips. For Soft back seat, there should be a zipper.
anyway, you have open up the back of the seat and disconnect the active head rest connector.
Make sure you disconnect the battery post first, so u dont set off an airbag light.
press the release button on the left, and Stick a Small pick or screw
driver to release a hidden button on the right.
Why does the Power Window Front Right goes down but not up! I have included further troubleshooting in the details below.
Power window motors are operated via two circuits; power and ground. The unique part about these circuits is that the direction that the motor rotates (moving the window up or down) is controlled by the direction of current flow using window switches. Window switches are all grounded in their default position but when they are moved to the UP or DOWN position they are connected to power instead. Here's how this works: when the master switch's right-front window switch is held to the UP position, the UP circuit is removed from ground and power flows through it, then passes through the UP circuit of the right-front window sub-switch, then to the window motor, then makes it's way through the DOWN circuit through the right-front sub-switch, then the master window switch, then to the common ground. When the master switch's right-front switch is held to the DOWN position, the DOWN circuit is removed from ground and power flows through it to the sub-switch, then to the window motor, then makes it's way to the common ground through the sub-switch and master switch's UP circuit. For your specific case I'd suspect that the master window switch's right-front switch connection to the DOWN circuit is not grounding by default like it should and therefore not providing a ground path for the motor when the UP circuit is energized. You can read more here: https://www.yourmechanic.com/article/how-to-replace-a-power-window-switch-by-marvin-sunderland
2013 3.6l. Where is the crankshaft position sensor?
Hello. Your vehicle's crankshaft position sensor is, usually, in front of the engine, right by the harmonic balancer 'pulley'. Some vehicles crankshaft sensor are in the rear of the engine; in the bell-housing. Good luck and keep me informed; if you want to.
Not finding what you are looking for?