20 Most Recent 2010 Toyota FJ Cruiser Questions & Answers

Check the switch on the steering wheel.

If you can open this door using a key - the problem is in the locking motor. Take off the door panel and give power to loking motor directly from the 12 V battery.

it might be in limphome mode.? why not scan it , and see what DTC errors there are, from TCM. or do all the tests in the FSM for , ON CAR SERVICE. FSM= factory service manual. ever try a tranny shop>? The key to service is doing the steps in the correct order 1: tranny ground trap good. (missing or damaged) 2: scan it. 3: check pump pressure and do the stall tests stated in the fSM. 4: level checks, and if wrong ATF in tranny ? 5: inputs to TCM wrong, ???? ECT, TPS, VSS1,2,3 6: reset TCM and try to see if learn mode , corrects bad shifting. OTTOMH, there are more. lots more, A/T are complex. lots to fail.

I have to do the same thing. From all I have read you have to remove all the inner plastic in the rear of the vehicle first. Then it is easy. there are three screws/nuts that hold the taillight assembly in.The main problem is to reach the frontmost (toward the front of the FJ) screw/nut in order to remove the whole apparatus. Hope this helps

No. It's the BLACK coloured vehicles -- harder to see after dark -- that are the worst.

take it back to your dealer,its new they have to fix it

Since it is a new 2014 run it down to your local Toyota dealer and have them fix it; since the FJ is still "new" it will be covered by warranty.

http://www.fjcruiserforums.com/forums/maintenance-tech/62188-serpentine-belt.html hope this helps

all else works perfect car drives runs, head lamps not dead or dim? just radio, check the radio fuse and post all modes of radio ,, AM/FM,CD/AUX,USB , all dead?

You can download the service repair manual safely from this website. Recommend it!

the switch in the door is bad.