2010 Saab 9-3 - Page 7 - Answered Questions & Fixed issues
Service engine soon light stays
Will not reset it's self you need to reset your ECM on your car's computer. Do this by Turniing your ign. key to on position then turn on a/c then disconnect your positive battery terminal. wait 30 sec then turn key off and replace battery cable. Good luck to ya. PS, If something else is a problem this will put the code back to your ecm and will come back on. But this should fix your problem.
Knocking sound when going over
if they are coils its only your coils touching each other.. it only means that the coils are too weak for you car and you have to replace them, or you could tighten them but that makes the ride very uncomfortable when you pass over a bump or in a pot hole.
I have a Saab 2.2tid
THE SAAB 9 -3 REMOTE BATTERY HAS TO BE REPLACED AND REPROGRAMMED AT THE DEALERSHIP.THE SAAB 9 - 5 YOU COULD REPLACE REMOTE BATTERY AND REPROGRAM OR SYNCHRONIZATION BY PRESSING REMOTE KEY BUTTON UNLOCK BUTTON AT LEAST 4 TIMES TO REPROGRAM KEY REMOTE TRANSMITTER.
My 2003 Saab 9-3 Linear
this code is set when the voltage to the ecm is not correct over an extended period of time-and indicates that the voltage regulator is not working properly. Your alternator is the issue, since the voltage regulator is internal to the alternator. Using a voltage meter (about $15 or less at virtually any auto parts store, get one that is digital) check your voltage when the car is not running (should be about 12.5 to 12.8 volts) and when running (should be 13.9 to 15.1 volts)-if it is outside these ranges, get a new alternator installed.
Best method of cutting bumper
Hi and welcome to FixYa!
Here in our motor shop, we use a metal plate or cutter to cut the bumpers in case of modifications. Heat up the blade or plate before proceeding to cutting procedure. When the metal blade is heated it makes the cutting easy.
Hope this helps and thank you for using FixYa! Have a good one!
I accidentally pulled the vacuum
Hi just push it back on again or make sure its blocked off with suitable plug the engine wont run as it is as it is going to run too weak due to the air leak
Hi I recently bought a
get the engine read - you should have a local part supply which offers free readings...
may have a fuel pump, fuel filter issue.
Ck
Could i get a diagram
Yup - CALL your local public library and see if they have the chiltons or even a haynes manual book there in the shelf, that will have the detail you need. If not available there, try calling around to your local parts stores...
Ck
Car will start and seem
Blown head gasket. You can do this yourself. You will have to get a manual as there are very important instructions that need to be followed. Plus the money that you save you can purchase any of the tools you don't have to do the job. ie... torque wrench
After an ice strorm, not
linkage bushing has either come off or linkage arm has broke...probably the first..they are just plastic. have a mechanic look at it..should be an easy fix.
Hi, I have a 2003
Check the gearbox wiring and solenoids, if all fine than it might be internal gearbox fault.
Kkk
Hi and welcome to FixYa!
May I know what your car problem is? Anyway, KKK is the group lead by a hero named Andres Bonifacio.
Hope you find this information helpful enough and thank you for using FixYa! Have a good one!
Hello, I have a 1999
You may have an air-mix door that is not functioning properly. It isn't operating to allow air flow to change direction and go through the other vent locations.
1. A trap door can simply be jamed.
2. You could have a bad vacume hose/connection, some use a vacume to open and close trap doors. Particularly from the floor vent to the upper vents
3. Some use electrical componets, an actuator to open and close doors.
This is very likely an easy repair.
Not finding what you are looking for?