20 Most Recent
2011 Kia Sedona Questions & Answers
Evap Leak parts and labor question.
Charcoal canisters aren't cheap. If you got a quote from a garage. This is cheap. not your problem though. Brought it to where I work and it was the problem, true problem, the part would cost more than $400. I replaced 1 canister. I have fixed all the rest of them. They are plastic.
How can I replace the evap canister in 2011 Kia Sedona?
How do you know the canister is bad?? There should be no issue with it being a 2011 unless you ran over something and damaged it. There are many things other than the canister that will cause evap leaks/codes. What code led you to the canister replacement idea?
Right turn signal possible short
the wire is shorted.trailer hitch hack job.collision damage to rear.? wrecked the harness.why would the flasher be bad, if left side front and rear works perfectlywe use a 15amp circuit breaker to replace the flasher fuse.then find the short, (beaker keeps popping) when right turns are selected.is this car under warranty?did some one put in an illegal larger fuse in this circuit? dontits a simple shorted linewe have a thing (real edison like) called an ammeterwe can measure the actual short, all look here its 15ampsjust as the breaker trips, bingo citythen all we do is start pulling all inline connectors to find the section that is shorted, front or rear.does that help?:
Right turn signal possible short
I think your flasher is working properly if its blinking fast while that light is out. I think you may have a grounding issue with the wires on that light. Unplug it again and look all down the wires to see if there are any cracks or brakes. You can take the bulb out and attach the positive lead to the bulb and ground it to the chassis. It should turn on. If it doesn't then your problem is in the positive lead, if it does turn on your problem is with the ground wire.
How do you get a stuck tailgate open?
if you can get the tailgate inner panel off , you may have to cut into it , you should be able to get to the lock mechanism , may be worth contacting KIA as vehicle must still be under warrenty if the 2011 year is accurate
How do I tighten the arm rest on a 2011 Sedona?
there should be a plastic cap on the sideof the arm rest pop it off and tighten the bolt. I think it is a 16 or 17mm bolt head. if there is no plastic cap you need to unzip the cover and tighten the bolt.
Not finding what you are looking for?