20 Most Recent 2010 Jeep Compass - Page 6 Questions & Answers

Hi there:"NO BUS" usually indicates a loss of communication between the various modules (computers) on the car. Would be the TIPM (Totally Integrated Power Module), but the dealership will need to do some diagnostics to determine the failure.Hope this helps.

It appears that the starter has staed engaged after the engine started. There is an override clutch on the starter pinion but it is only good for a short time. It seizes up and the starter starts spinning and trying to generate power. In the end it burns out. Pull the starter and have it check out.

look for fuel leak around the fuel manifold area Look for cracked supply and return rubber hoses look for loose clips on hoses. Check for leaking injector lines

seven days left on the auction for the whole manual set.http://www.ebay.com/itm/2012-JEEP-COMPASS-OWNERS-MANUAL-GUIDE-BOOK-CASE-SET-12-/330798373437?pt=Motors_Manuals_Literature&hash=item4d051e9a3d&vxp=mtr

Check the antenna for a good ground, if the antenna is ok have the radio removed and repaired by a factory repair center.

check for power at the fuel pump if no power check relay's fuses ect If you have power at the pump then most likely bad fuel pump.And yes they do quit just like that