20 Most Recent
2011 Ford F-350 Super Duty - Page 2 Questions & Answers
Check engine light is always
do a generic obd2 test it will show what codes are set / if light is allways on ti is a hard code
the vehicle is more than likely in default
How do i program my garage door opener on my 2011
The process is simple but too lengthy to post here.
Goto homelink.com
They make the system and have very complete instructions you can download.
PLEASE NOTE: MOST but not ALL Brands / models of opener will work with this system.
Spark plug insert
I have replaced one in my ford exp. It was easy but mine was toward front of engine and easy to get to. I am not sure where #10 is on your 350.
Spark plug inserts
Google the question & read up on it
Go to You Tube Video & watch
All your questions are on the internet
Won't be easy, unless you have to experience &
touch of a machinist
Look at the tool required on the net & see how it is used
Fuel in water
Mr. Harris, My advise is to drain the water and fuel mixture from your fuel tank,remove if is easy the fuel tank and completely dry it up,Go by the engine bay and find the fuel pipe which is coming from the tank to the injection system where probably is a fuel filter,renew the fuel filter, blow air in the pipe from the engine side towards the fuel tank-but before you do blow air in the pipe be sure is not connected to the fuel tank,for not sending the water back in. If you did not start the car since water went into fuel,means that you finished with the above,by connecting everything and put fuel in the tank and start the engine. If you did have the engine running when water went into fuel,means that you have to remove the spark plugs and whilst are out and the fuel tank is clean with new fuel and fuel filter make the engine spinning second to second for 2-3 minutes so as the any old fuel to push out from the spark plug holes. After clean your spark plugs or renew them and also before running the engine is good to put an injection cleaner additive in the fuel tank. Better to put fuel up to a quarter of the tank and run it treating all the system.
Cracked bell housing
My initial thought is Aluminum can be welded. Depends on cracks relationship to mounting bolts. Check and see if Bell housing is separate from transmission. May be able to swap bell housings and keep transmission.
You may want a good Salvage yard site like Carparts.com. They have a Nationwide link to many Salvagers. One request and you could get 300 responses.
Swerves alot while driving
Something seriously loose or worn:
- steering box mounts
- steering column universal joint or end clamp
- steering box inner ball joints
- tie rod ends
- outer ball joints
- wheel centre hub nut
- wheel stud nuts
A simple test is to jack up both front wheels and place the vehicle on axle stands. Then have someone hold the steering wheel, grab a front wheel at the 9-and-3 o'clock position, and shake it hard in and out. If you can feel slack or looseness, or the person holding the steering wheel can, you have a dangerous fault which should be fixed ASAP.
Not finding what you are looking for?