Top 20 2012 Fiat 500 Questions & Answers

Try PROXI alignment through diagnostic if not fix then the blue&me ecu has failed and needs replacement try a quick fix through battery + on / off plug

Rolly: According to Fiat500USAforum.com: "What is causing your problem is the Ecodrive program. You can disable this using the Voice Response system I think the command is Ecodrive disable...but you might want to check the owners manual. I used the system with a thumbdrive, but lost interest and turned it off using the VR button on the steering wheel and voice commands. "

Sounds like it could be a fuse unless the switch is no good.

We have had those lights on the dash of all vehicles for 34 years Did you read your owners manual ? Your vehicle has a system fault to be diagnosed

With the key off, remove the radio fuse from the fuse box, start the car (there should be no power to the radio if you got the right fuse pulled), turn turn the car off, then then put the fuse back in. That should reset it. In my 2013 Fiat 500 it's the 3rd fuse up from the bottom, on the left side of the bus. 10amp, red fuse. (If you're unsure, use the web to look up a map of the fuses for your make\model\year. Don't justt start unplugging fuses... you may strand yourself.) -Good Luck!

First twist the upper part of antenna to the left .if this doesn't work then remove the plastic cover(if there is one) and search for any screws from outside ,but you might have to remove the inside fabric under it. The Stubby Antenna for Fiat

Take the radio out and remove the coins is the first thing i would advise

check the fuse first if both lights arnt working. u can change by the access panel inside car behind light. turn and pull and light comes out

in the boot on the right hand side is a plate number with vehicle model and identification...and is a plate also on the left hand side ...where is the spare wheel...i hope you will find...cheers

Hi Melissa, How did you manage to fix the problem with the two bolts? I have the same problem with my alfa romeo 159 2.0 jtdm.

check to see if you have anymore fluid in the reserve. if you do maybe you have a break like thats is leaking.

To remove the key, you take off the steering wheel covers. Underneath, there is a red tab to push in. Push in the red tab and remove key. Fuel cut off is your next problem. You use your directionals to reset the airbag module to turn on fuel. The procedure is listed in the owners manual under " in case of accident"

This can't be repaired to look like new. This is a warranty item, take it back.

If its a painted plastic bumper cover and everything underneeth is fine a body shop should only charge around 150 to $200

From my User Guide p. 63: 8,000 miles or 6 months - oil and filter change, rotate tires. At 16,000/1 yr more extensive inspections and filter changes.

You will need to contact a fiat dealer to get the code. They will require Vin number and proof of vehicle ownership.

With all doors closed, put key in ignition and turn key to first position only, and fully depress and release the accelerator pedal 5-7 times. Pedal must be pressed all the way down and fully released these 5-7 times. I hope this helps!

You can adjust the display in the settings menu, by pressing the menu button on the right side of the speedo, and using the buttons directly above to toggle through your choices.

try it and find out

This appears to be a well known issue. I found this Solved maybe . I had the same issue when i changed one of the Daylight Running Lights in the front and one of my rear brake lamps. I ended up changed both brake lamps since its a two pack, the front lights all looked well. The rear, one was off even if i changed both. I was puzzled but then tried to turn off my DRL from the menu section on the front panel which didn't work. Opened the brake lamps and checked them again and they all worked. I reset my error codes (check your manufacturer book) mine was 5 pumps with engine off then key out and then engine on. The "check running lights" code disappeared as well. Make sure to check all your lights are on(front back. Hope that works for one of you at least! and also I has the exact same issue. DRL going out when headlamps turned on. I found the problem. It's a simple fix. It was a bad connection between the bulb and the bulb holder. I noticed wiggling the bulb made it come on and off. The fix is to bend the exposed wires on the bulb so that they stand proud rather than squashed flat against the bulb. I did it by gently prizing them away from the bulb and then I put a small screw driver underneath it and pressed the wire back down again. You could use a cocktail stick or march stick or similar. This makes the contact between the bulb and the holder tighter. Job done. Lots more here. https://www.google.com/search?q=2009+Fiat+500.+Yellow+triangle+on+dash+%27check+running+lights%27 ..