20 Most Recent 2010 Dodge Nitro Questions & Answers

Dodge, you have to pay for it- usually the schematics are provided for a time period and then you will loose access unless you pay again. Good Luck

door actuator not turning

Check for air in the cooling system - tighten carefully all hoses especially ones by expansion tank. If motor on cool down sucks in air instead of water an air bubble could restrict the flow of coolant into the heater core.

This seems to be a problem with the actuator for the mode door in the heater housing. It shouldn't require replacement of the heater housing, but may require a lot of work to get to the heater housing (possibly removal) to replace the actuator. If you want air to be directed to the floor or the dash vents, you will have to have the actuator repaired/replaced.

In the Fuse box which is located on Right side of Glove box which is on Pass. side of car.

Fuse box is on the right side of the glove box wich should be on the Pass. side of the car.

It makes no difference because the switch is never repaired just replaced.

Remove the center console. It is under it. Better make sure that is the problem though. Could be wiring. Lots of things to check before replacing any part of it. This is the most common reason cars are totaled, Air bags. Even if they weren't deployed.

-Possibly burn fuse. Check and replace it. Good Luck Mai

-Heater hose valve not open or the hoses are clogged. Good Luck mai

Blend air door inop, either from vacuum leak, bad check valve or bad actuator.

I would pull off the blend door actuator and swap it out with a new one. Or another option is to swap it out with one of the other actuators. The blend door actuator is interchangeable with the actuators for the mode-air doors and the recirculation-air door. Disconnect and isolate the negative battery cable. If equipped, remove the silencer from below the driver side of the instrument panel. Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing. Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator

Do you mean the fan or no heat?. Do you have a temp gauge on the dash and does it look normal? It could be a stick open thermostat.

IN TOTALLY INTEGRATED POWER MODULE

have to take to dealer

Get the car read by an OBD scanner so you know why it is on and then you can erase the code.