2004 Chevrolet Venture - Answered Questions & Fixed issues

Videos and articles https://www.google.com/search?q=Remove+middle+seat+2004+Chevrolet+venture ..

What do you mean by shorted?

Slide under at the rear of the back axle and pull the ebrake cable back off at the center of the axle,then push the cables into each of the rear wheels to release.

Have you tried the drivers door "passenger door window switch" and the passenger "door window switch" to try and roll the passenger window up?When you do try to roll it up make sure the vehicle is running as you want the most voltage to the window motor.If both door switches would not roll the window up,try the following. With the engine running hit the up window switch on the passenger door just as you give the door a HARD FIRM RAP.The window should roll up.It may take a few tries.DO NOT roll the window back down until you have changed or dissembled the window motor for a good cleaning.Also,check for broken wires at the door hinge area on both the drivers and passenger sides,pull each wire firmly looking for a broken wire.

I don't think you can disable all wheel drive. All 4 wheels work in harmony to drive the vehicle. Lift one wheel off the ground and try to drive, It will not move.

do you mean posidrive?

need engine size...

If all the rest of the lights in the dash are working, then it is the bulb. Just pull out the dash and replace bulb

I have a 2004 venture ext. van and the fuel gauge doesn't work. Any suggestions?

Question edited to fix Fixya redacting a word it doesn't like. Question moved from Misc to model category. https://www.google.com/search?q=fix+the+petcock+on+Chevy+Venture ,,

It is on the fuel pressure regulator https://troubleshootmyvehicle.com/gm/3.8L/how-to-test-the-fuel-pump-1 https://www.2carpros.com/questions/chevrolet-venture-2000-chevy-venture-fuel-pressure-regulator--2 ..

get a gas cap their cheap

Its a long way from the gas tank to the engine so you need a fair bit of cranking. Also, if it ran dry, it means the pump also was running dry after it stopped. The gas lubricates and cools the pump, so you may have wrecked it. First thing, check that fuel is being pumped. Then check the pressure.

Some fixya user told me a website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

hello u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

you can try out some guide from here reliable-store they also provide live chat fe ature for instant help and it's very useful

Hi have you had any joy finding fault I have the same problem with my Maxus. I've replaced endless stuff even main pump ,narrowed it down to crank position sensor.but sensor is fine there should be a 5v feed but there isn't one ,checked wire back to ecu and its ok. But carnt see it being fault on ecu van drives and performs great once running. Seems to be quite a common thing on these but no one seems to have an answer, if you have any joy with yours or need any questions over it you can contact me on [email protected] for number , cheers dave

I believe it is a electric hydraulic system so maybe a bad switch or wire or hydraulics could be getting varnished and sticking

I believe the shake is coming from your transmission. Please look at the fluid level and color. Also take a look at its maintenance history. When was the last time the fluid and filter was replaced? The torque converter clutch, low transmission fluid pressure, and engine issues will cause shudder (Clogged air and fuel filter, poor fuel pressure, fouled spark plugs, timing or restricted exhaust flow). Please let me know if this helps and if there is anything else. Good Luck.