20 Most Recent
2009 Volkswagen Rabbit - Page 2 Questions & Answers
Heater fan or blower motor
Test the fuse , tight the wires and clean the connector.however you can go to www. autoelectronico.com translate the website with your browser and get the topic and fix it.God bless you
Vw rabbit 06 abs module needs replacing; how to
un bolt the pipes off don't damage them unplug the abs unit. then unbolt from frame. keep a rag with you and don't let the oil coming out touch the paint work as it can and will take your pain off. replace. then you need to re bleed the braking system starting at the far end of the braking line. usually rear right wheel. then left then right front then left. you will need a lot of new oil as the air in the system will be were you have taken off the abs. do this bleeding to the lines until the air comes out. then the system will be working fine again then. make sure you get the same abs unit same serial number and part number some times the last digit is different this is ok but if it is 2 digits out that is not the one.
1983 rabbit the manual transmission linkage is messed up?
You can't get parts for this anymore, so I suggest you start looking for a good used shifter. Use an Internet search engine for used VW parts, just google it and lots of salvage yards will contact you with prices and availability. Here is a
LINK to try.
2.0 sdi running on 3 have changed fuel filter
Your not too bright--- I'm sorryChanging a gas filter & then saying it ran a lot betteris not correct at all.The problem comes back 220 miles later--so you changethe fuel filter again,absolutely stupidYou know that one cylinder is not contributing,would younot go to a repair shop to have that resolved
Where is the air pollition filter for a 2008 vw rabbit
the air filter is in the engine cover. the engine cover is also the air filter box. you have to pull the cover off. then flip it over and there are 4 screws holding the air filter. loosen those screws then take the air filter out, replace it and put the screws back on, then gently put the cover back ontop of the engine. make sure you fit the four holes with the the four studs exactly
Not finding what you are looking for?